User manual MTD MAC 3516

[. . . ] Read the whole manual and follow all the instructions to keep your new outdoor power tool in top operating condition. 8 PRODUCT REFERENCES, ILLUSTRATIONS AND SPECIFICATIONS All information, illustrations, and specifications in this manual are based on the latest product information available at the time of printing. We reserve the right to make changes at any time without notice. Inside Back Cover SERVICE INFORMATION Service on this unit both within and after the warranty period should be performed only by an authorized and approved service dealer. [. . . ] Place the charging station where the unit is intended to be stored. This should be a cool, dry and well ventilated place, where the unit can be locked-up and out of the reach of children. The unit should be stored and charged in a location where the temperature is between 50˚F (10˚C) and 100˚F (38˚C). Locate a place for the charging station near a wall outlet and high enough to keep the unit off the floor. Locate the wall stud and mount the charging station to the wall using the three (3) screws provided (Fig 3). Make sure that the screws enter the wall stud to provide a secure mount. Hold the unit in the operating position. If necessary, reposition the D-handle to the location that provides the best grip (Fig. 3 CAUTION: To prevent injury or damage to the unit, the charging station must be mounted securely to the wall. Plug the charger into the wall outlet and wind any excess wire onto the cord wrap on the charging station (Fig. Tighten the wing nut until the D-Handle is secure. Allow the tip of the line to do the cutting, especially along walls. Cutting with more than the tip will reduce cutting efficiency and may overload the motor. € Cut grass over 8 inches (200 mm) by working from top to bottom in small increments to avoid premature line wear or motor drag. € Cut from right to left whenever possible. Cutting to the left improves the unit's cutting efficiency. Clippings are thrown away from the operator. € Slowly move the trimmer into and out of the cutting area at the desired height. € Trim only when grass and weeds are dry. € The life of your cutting line is dependent upon: • Following the trimming techniques previously explained • What vegetation is cut • Where vegetation is cut For example, the line will wear faster when trimming against a foundation wall as opposed to trimming around a tree. WARNING: Clear the area to be cut before each use. Remove all objects such as rocks, broken glass, nails, wire, or string which can be thrown or become entangled in the cutting attachment. [. . . ] ) of line is outside of the cutting attachment SPECIFICATIONS BATTERY AND MOTOR Motor . (254 mm) 15 MANUFACTURER’S LIMITED WARRANTY FOR: The limited warranty set forth below is given by MTD LLC (“MTD”) with respect to new merchandise purchased and used in the United States, its possessions and territories. MTD warrants this product against defects in material and workmanship for a period of two (2) years commencing on the date of original purchase and will, at its option, repair or replace, free of charge, any part found to be defective in material or workmanship. This limited warranty shall only apply if this product has been operated and maintained in accordance with the Operator’s Manual furnished with the product, and has not been subject to misuse, abuse, commercial use, neglect, accident, improper maintenance, alteration, vandalism, theft, fire, water or damage because of other peril or natural disaster. [. . . ]