User manual MTD MB2800

[. . . ] 45132 Made in Taiwan/Fabriqué à Taiwan/Hecho en Taiwan SAFETY OPERATION MAINTENANCE SECURITE FONCTIONNEMENT ENTRETIEN SEGURIDAD OPERACION MANTENIMIENTO WARNING • PLEASE READ For your own safety please read this manual before attempting to operate your new unit. Failure to follow instructions can result in serious personal injury. Spend a few moments to familiarize yourself with your blower before each use. PN 9096-320002 © McCulloch Corporation, 2001 • Printed in Taiwan PLEASE READ E N G L I S H The WARRANTY SYMBOL indicates that unless instructions or procedures are followed any damage caused will void the warranty and repairs will be at owner’s expense. [. . . ] Install cover screw (K) through tube tab and into housing. Slide handle (A) into the groove in the housing (B). INSTALLATION OF SPARK ARRESTER L A spark arrester screen is required when using your blower on U. Remove the 2 small muffler screws (A) (Figure 4-5A). Grasp cover (B) and screen (C), and insert first screw (D) (Figure 4-5B). Install onto muffler and secure first screw. RECOMMENDED FUELS Some conventional gasolines are being blended with oxygenates such as alcohol or an ether compound to meet clean air standards. Your McCulloch engine is designed to operate satisfactorily on any gasoline intended for automotive use including oxygenated gasolines. STARTING A COLD ENGINE Fill fuel tank with proper gas and oil mixture. Set unit on ground so that it rests on housing feet. Hold trigger at fully depressed position or set throttle lock: While holding trigger (A) at wide open position, press throttle lock (B). Release trigger (A), then release throttle lock (B) (Figure 6-1A). Pump the primer bulb (C) 10 times (Figure 6-1B). Your unit is designed with a 3 position choke (D), CHOKE “ ”, START “ ”, and RUN “ ”. Pull starter rope out a short way until resistance if felt (approx. A smooth rapid pull is required for a strong spark (Figure 6-1D). Pull starter rope again 4 times while trigger is still in the fully depressed position (Figure 6-1E). RECOMMENDED FUELS Some conventional gasolines are being blended with oxygenates such as alcohol or an ether compound to meet clean air standards. Your McCulloch engine is designed to operate satisfactorily on any gasoline intended for automotive use including oxygenated gasolines. STARTING A COLD ENGINE Fill fuel tank with proper gas and oil mixture. Set unit on ground so that it rests on housing feet. Hold trigger at fully depressed position or set throttle lock: While holding trigger (A) at wide open position, press throttle lock (B). [. . . ] NOTE: If vacuum bag is unusually dirty, it should be washed by hand in warm water with a mild detergent. Failure to follow these steps may cause varnish to form in the carburetor and difficult Fig. 8-7A starting or permanent damage following storage. Perform all the general maintenance recommended in the Maintenance Section of your User Manual. [. . . ]