User manual MTD MS1838AV

[. . . ] ¤ ¤ USER MANUAL Gasoline Chain Saws MANUEL DE UTILISATION Tronçonneuses à essence MANUAL DEL USUARIO Sierras de Cadena de Gasolina STOP ARRÊT ALTO Models : MS1432, MS1435, MS1635, MS1635AV, MS1838AV, MacCat Super 16 AV For problems or questions, DO NOT return this product to the store. Box 361131 Cleveland, OH 44136-0019 Canada Imported by / Importé par: MTD PRODUCTS LIMITED 97 Kent Avenue Kitchener, ON CANADA N2G 4J1 For Consumer Assistance Please Call L'Aide Du Consommateur Necessitez S'il Vous Plait Para La Ayuda Del Consumidor Llame Por Favor This product has been tested at a computed kickback angle (CKA) of no greater than 23. Hold chain saw firmly with both hands when using. For your own safety, please read and follow the safety precautions in this manual before attempting to operate your chain saw. [. . . ] Fill the fuel tank (A) with correct fuel mixture (Figure 5-1A). Fill the oil tank (B) with correct chain and bar oil (Figure 5-1A). Be certain the CHAIN BRAKE® is disengaged (C) before starting unit (Figure 5-1A). Push the primer bulb (F) 10 times (Figure 5-2D). Make sure the switch is in the ON position. Release trigger and allow engine to return to idle speed. I ® S NOTE: For emergency stopping, simply activate CHAIN BRAKE and move STOP switch down. CHAIN BRAKE OPERATIONAL TEST Test the CHAIN BRAKE® periodically to ensure proper function. Perform a CHAIN BRAKE® test prior to initial cutting, following extensive cutting, and definitely following any CHAIN BRAKE® service. tEST CHAIN BRAKE® AS FOLLOWS: F 1. Place saw on a clear, firm, flat surface. Latch throttle advance: depress latch and hold (A) squeeze throttle trigger (B) release trigger and then the latch (Figure 5-2E). Hold saw firmly and pull starter rapidly 4 times. Depress and release trigger (E) for IDLE, then go to step 9 (Figure 5-2J). If engine failed to start, repeat these instructions. Make sure the switch is in the ON position. Release trigger and allow engine to return to idle speed. I ® S NOTE: For emergency stopping, simply activate CHAIN BRAKE and move STOP switch down. CHAIN BRAKE OPERATIONAL TEST Test the CHAIN BRAKE® periodically to ensure proper function. Perform a CHAIN BRAKE® test prior to initial cutting, following extensive cutting, and definitely following any CHAIN BRAKE® service. tEST CHAIN BRAKE® AS FOLLOWS: F 1. Place saw on a clear, firm, flat surface. [. . . ] Running the saw dry or with too little oil will decrease cutting efficiency, shorten saw chain life, cause rapid dulling of chain, and lead to excessive wear of bar from overheating. Too little oil is evidenced by smoke or bar discoloration. Bar Length 14” Bar 16” Bar 18” Bar Drive 49 54 60 Links DL DL DL Bar 214235-33 214236-33 219276-33 Chain 214919-33 214925-33 219275-33 There may be other quality equivalent replacement components for achieving kickback protection. CHAIN SHARPENING: Chain sharpening requires special tools to ensure that cutters are sharpened at the correct angle and depth. [. . . ]