User manual MTD MT202A13

[. . . ] 525 Southgate Drive, Unit 2 Guelph, Ontario N1G 3W6 WARNING • PLEASE READ For your own safety please read this manual before attempting to operate your new unit. Failure to follow instructions can result in serious personal injury. Spend a few moments to familiarize yourself with your trimmer before each use. With proper operation and maintenance it will provide you with years of service. [. . . ] DRESS PROPERLY - Always wear long pants, shoes and gloves. Do not wear loose clothing, jewelry, short pants, sandals or go barefoot. KEEP AREA CLEAR - Keep everyone, especially children and pets away from the area of operation. Turn off unit immediately if you are approached. Never allow children to operate the appliance as a toy or to run the appliance unattended at any time. E S P 3-1A 3-1B CONSERVE ESTAS INSTRUCCIONES C C 2 - INTERNATIONAL SYMBOLS - SYMBOLES INTERNATIONAUX SIMBOLOS INTERNACIONALES 3-1C Use of these personal safety items is highly recommended to reduce the risk of accidental injury. E N G L I S H 3-1B NOTE: The only assembly required for your trimmer is to install the edge guide wheel, debris shield and adjust the assist handle. Position the motor housing with string head carrier facing up. Use of these personal safety items is highly recommended to reduce the risk of accidental injury (Figure 2-2). E S P 3-1A 3-1B CONSERVE ESTAS INSTRUCCIONES C C 2 - INTERNATIONAL SYMBOLS - SYMBOLES INTERNATIONAUX SIMBOLOS INTERNACIONALES 3-1C Use of these personal safety items is highly recommended to reduce the risk of accidental injury. E N G L I S H 3-1B NOTE: The only assembly required for your trimmer is to install the edge guide wheel, debris shield and adjust the assist handle. Position the motor housing with string head carrier facing up. Push shaft release button (A) and move motor housing forward or backward to desired length. Push edge button (B) and rotate handle assembly until an audible click is heard. ADJUST THE ASSIST HANDLE NOTE: The assist handle is attached to the shaft but has been turned under for packing 1. When starting the string-trimmer for the first time, check that the nylon line touch or pass over the wire-cutting blade. If they are not long enough, press the bump knob and, at the same time, pull the nylon line. Make sure the length of grass trimmer and position of assist handle is most applicable before use, adjust the length of grass trimmer by pressing the shaft adjustment button, adjust the height of assist handle by loosening the adjustment knob. Take a secure hold of the grass trimmer and, without letting it touch the grass to be cut press the safety switch then N press the switch on the upper handgrip. Let the string trimmer run for a few seconds and “bump” the stringhead against the lawn. The cut-off knife in the debris shield will trim off excess line. To switch off the string trimmer let go of the switch. [. . . ] To do so, hold the outer ribbed part of the assembly with one hand, while pushing down and turning the spool head with the other to unlock it. NOTE: There is a spring inside the string head that could easily be lost. Remove any existing line from the spool. 065" replacement line measure off approximately 14' of line. [. . . ]