User manual MTD OEM-190-099

[. . . ] With proper operation and maintenance it will provide you with years of service. In order to make the best use of your investment, be CERTAIN to familiarize yourself with the contents of the ENTIRE User Manual before attempting to operate and maintain your unit. Be sure to carefully follow the step-by-step illustrations in this manual to start, operate and maintain your new product. In the manual there will be the following call-outs: NOTE, WARNING / CAUTION and WARRANTY. [. . . ] A NOTE is used to convey additional information, or highlight a particular explanation, or to expand a step instrucI tion. A WARNING identifies a procedure which, if not undertaken or if improperly done, can result in a serious personal H injury or damage to the unit and/or both. (WARRANTY SYMBOL) serves notice that unless instructions or procedures are followed, any damage will void the warranty and repairs will be at owner’s expense. Service other than user maintenance should be performed by a Troy Bilt Authorized Service Center. Damage or conditions caused by improper maintenance practices which render this product inoperablewill void the manufacturer’s warranty. Do not operate without debris shield attached. DRESS PROPERLY - Always wear long pants, shoes and gloves. Do not wear loose clothing, jewelry, short pants, sandals or go barefoot. KEEP AREA CLEAR - Keep everyone, especially children and pets away from the area of operation 50 feet (15m). Turn off unit immediately if you are approached. Never allow children to operate the appliance to be used as a toy or E to run unattended at any time. NOTE: To make installing or removing the attachment easier, place the unit on the ground or on a work bench. While firmly holding the attachment, push it straight into the coupler until the release button appears in the primary hole of the coupler. 3-4C) The release button must be in the primary hole and the knob securely tightened before operating this unit. All attachments are designed to be used in the primary hole unless otherwise indicated in the specific attachments operators manual. If the incorrect hole is used, it could result in injury, or damage to the unit. NOTE: Turn attachment rotating parts by hand to and fro to have the attachment shaft connect to the powerhead drive shaft slot more easily. Position the unit with the string head carrier facing up Align disposable string head locking tabs with corresponding slots in carrier as shown (Figure 3-3A). With firm pressure push disposable string head onto carrier until an audible click is heard. Press yellow button on side of string head to eject used REX disposable string head (Figure 3-3B). To avoid serious personal injury, shut unit off before removing or installing attachment. NOTE: To make installing or removing the attachment easier, place the unit on the ground or on a work bench. [. . . ] This limited warranty shall not extend to anyone other than the original purchaser, original lessee or the person for whom it was purchased as a gift. How State Law Relates to this Warranty: This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. Troy-Bilt LLC PO Box 361131 Cleveland, OH 44136-0019 19 20 MANUFACTURER’S LIMITED WARRANTY FOR: GARANTIE LIMITÉE DU FABRICANT POUR: The limited warranty set forth below is given by Troy-Bilt LLC with respect to new merchandise purchased and used in the United States, its possessions and territories. Troy-Bilt LLC warrants this product against defects in material and workmanship for a period of two (2) years commencing on the date of original purchase and will, at its option, repair or replace, free of charge, any part found to be defective in material or workmanship. [. . . ]