User manual MTD OEM-190-626

[. . . ] It lists the model and serial numbers of your unit. Refer to the sample plate below and copy the information for future reference. 6 In an effort to reduce the impact on the forests, and reduce carbon and greenhouse gas emissions, MTD is using less paper by reducing the text size of this manual. P/N 38801334 P00 Copy the model and parent part number here: Copy the serial number here: All information, illustrations, and specifications in this manual are based on the latest product information available at the time of printing. [. . . ] Remove the rubber protector from the end of the upper boom (Fig. Unfold the unit so that the lower boom is in line with the upper boom (Fig. NOTE: Make sure the coupler buckle is in the clamped position and that the coupler is at the top of its travel area on the lower boom. Make sure not to let the lower boom drop or pull excessively while unfolding the unit. Slide the top of the lower boom shaft into the bottom of the upper boom shaft and push together until the coupler is snug against the upper boom. Using a 4mm Allen Wrench tighten the upper Allen bolt until the coupler is secure and will not move on the upper boom. Place D-handle over the shaft housing and onto the bottom clamp (Fig. Start screws with a large Flat-head or T-25 Torx screwdriver. Do not tighten until you make the handle adjustment. While holding the unit in the operating position (Fig. 13), move the D-handle to the location that provides you the best grip. € Slowly move the trimmer into and out of the cutting area at a desired height. move either forwardbackward or side-to-side motion. Cutting short lengths produces the best results. € Trim only when the grass and weeds are dry. € The life of your cutting line is dependent upon: • Following the trimming techniques previously explained • What vegetation is cut • Where the vegetation is cut. For example, the line will wear faster when trimming against a foundation wall as opposed to trimming around a tree. dECORATIVE TRIMMING Decorative trimming is accomplished by removing all vegetation around trees , posts , fences and more. Rotate the unit so that the cutting head is at a 30˚ angle to the ground (Fig. 14 WARNING: To prevent serious personal injury, never operate the trimmer without the cutting attachment shield in place. Turn the unit over so that the cutting head is facing up (Fig. Using a Philips head screwdriver, remove the three screws from the cutting head. [. . . ] - Neutralize with lemon juice, vinegar or other mild acid. Failure to follow safety rules listed below may result in electric shock, fire and / or personal injury. NOTA: Failure to wind the line in the direction indicated will cause the cutting head to operate incorrectly. 17 NOTAS 18 NOTAS 19 MANUFACTURER’S LIMITED WARRANTY FOR: GARANTIE LIMITÉE DU FABRICANT POUR: GARANTÍA LIMITADA DEL FABRICANTE PARA: The limited warranty set forth below is given by Troy-Bilt LLC (“TROY-BILT”) with respect with new merchandise purchased and used in the United States, its possessions and territories. [. . . ]