User manual MTD OEM-390-680

[. . . ] We reserve the right to make changes at any time without notice. copyright© 2007MTD SOUTHWEST INC , All Rights Reserved. MODEL : S/N : ITEM : Copy the model and parent part number here: Copy the serial number here: P/N 769-03201 (4/07) RULES FOR SAFE OPERATION • IMPORTANT SAFETY INSTRUCTIONS • SPARK ARRESTOR NOTE NOTE: For users on U. Forest Land and in the states of California, Maine, Oregon and Washington. [. . . ] 16 NOTE: Always keep the trimming line fully extended. Line release becomes more difficult when the cutting line gets shorter. 9 OPERATING INSTRUCTIONS DECORATIVE TRIMMING Decorative trimming is accomplished by removing all vegetation around trees , posts , fences and more. Rotate the whole unit so that the cutting attachment is at a 30° angle to the ground (Fig. TIPS FOR BEST EDGING RESULTS • Keep the cutting attachment perpendicular to the ground. Then edge the area again with a deeper setting. € Walk the edger at a slow, even pace • Check the blade’s condition often. As the blade wears, it becomes smaller, reducing the cutting depth performance. depth Adjustment Knob Raise Depth Fig. 17 HOLDING THE UNIT WITH EDGER ADD-ON WARNING: Always wear eye, hearing, foot and body protection to reduce the risk of injury when operating this unit. Before operating the unit as an edger, stand in the operating position (Fig. 41 mm) trimming line, 10 feet (3 m) long. Hold the outer spool and turn the inner reel counterclockwise to line up the arrows on the outer spool and inner reel (Fig. Pull old line out of the line loading and line locking holes (Fig. Top View Of The SpeedSpool® Outer Spool Arrows WARNING: Always use the correct line length when installing trimming line on the unit. The line may not release properly if the line is too long. Insert a piece of trimming line straight into one of the two eyelets in the outer spool. Push it up through the line loading hole in the inner reel (Fig. Do not bend the line when inserting it into the eyelet. Insert the line into the locking hole (Fig. Do not push the line more than a 1/2 inch (12. Pull the line from the outer spool until the line is tight against the inner reel (Fig. [. . . ] (10) Troy-Bilt shall provide any documents that describe the warranty procedures or policies within five working days of request by the Air Resources Board. Emission Warranty Parts List (1) Fuel Tank Written instructions for the maintenance and use of the evaporative emissions control system by the owner shall be furnished with each new engine or equipment. MANUFACTURER’S LIMITED WARRANTY FOR: The limited warranty set forth below is given by Troy-Bilt LLC (“Troy-Bilt”) with respect with new merchandise purchased and used in the United States, its possessions and territories. Troy-Bilt warrants this product against defects in material and workmanship for a period of two (2) years commencing on the date of original purchase and will, at its option, repair or replace, free of charge, any part found to be defective in material or workmanship. [. . . ]