User manual MTD PM1846AV PARTS LIST

[. . . ] This unit is factory equipped with a spark arrestor. It will help you assemble, prepare and maintain the unit for best performance. Please read and understand what it says. Before you start assembling your new equipment, please locate the model plate on the equipment and copy the information from it in the space provided below. [. . . ] In cold weather, let the engine warm up for 30 to 60 seconds. NOTE: If the engine stalls while squeezing the trigger, go back to step 5. Release your hand from the throttle control (Fig. Allow the engine to cool down by idling. Put the On/Off Stop Control in the OFF (O) position (Fig. 23 12 OPERATING INSTRUCTIONS OPERATING THE EZ-LINK™ SYSTEM The EZ-Link™ system enables the use of these optional Add-Ons. TBTB WARNING: Read and understand the operator’s manual for each add-on prior to operation. While firmly holding the add-on, push it straight into the EZ-Link™ coupler (Fig. NOTE: Aligning the release button with the guide recess will help installation (Fig. While firmly holding the upper shaft housing, pull the cutting attachment or add-on straight out of the EZ-Link™ coupler (Fig. WARNING: To avoid serious personal injury and damage to the unit, shut unit off before removing or installing add-ons. € Cut grass over 8 inches (200 mm) by working from top to bottom in small increments to avoid premature line wear or engine drag. € Cut from left to right whenever possible. Cutting to the right improves the unit's cutting efficiency. Clippings are thrown away from the operator. € Slowly move the trimmer into and out of the cutting area at the desired height. € Trim only when grass and weeds are dry. € The life of your cutting line is dependent upon: • Proper adherence of trimming techniques (explained above) • What vegetation is cut • Where vegetation is cut For example, the line will wear faster when trimming against a foundation wall as opposed to trimming around a tree. 27 ADJUSTING TRIMMING LINE LENGTH The Bump Head™ cutting attachment allows you to release trimming line without stopping the engine. To release more line, lightly tap the cutting attachment on the ground (Fig. 28) while operating the trimmer at high speed. NOTE: Always keep the trimming line fully extended. [. . . ] Any replacement part that is equivalent in performance or durability may be used in non-warranty maintenance or repair and will not reduce the warranty obligations of the manufacturer • The following components are included in the emission related warranty of the engine, air filter, carburetor, primer, fuel lines, fuel pick up/ fuel filter, ignition module, spark plug and muffler. 27 MANUFACTURER’S LIMITED WARRANTY FOR: The limited warranty set forth below is given by Troy-Bilt LLC with respect to new merchandise purchased and used in the United States, its possessions and territories. Troy-Bilt LLC warrants this product against defects in material and workmanship for a period of two (2) years commencing on the date of original purchase and will, at its option, repair or replace, free of charge, any part found to be defective in material or workmanship. This limited warranty shall only apply if this product has been operated and maintained in accordance with the Operator’s Manual furnished with the product, and has not been subject to misuse, abuse, commercial use, neglect, accident, improper maintenance, alteration, vandalism, theft, fire, water or damage because of other peril or natural disaster. [. . . ]