User manual MTD PROMAC 3505

[. . . ] This modern outdoor power tool will provide many hours of useful service. You will find it to be a great labor-saving device. This operator’s manual provides you with easy-to-understand operating instructions. Read the whole manual and follow all the instructions to keep your new outdoor power tool in top operating condition. [. . . ] Your McCulloch engine is designed to operate satisfactorily on any gasoline intended for automotive use including oxygenated gasolines. MIXING FUEL Mix fuel with Genuine Factory Parts brand 2 cycle oil in an approved container. Use mixing table for correct ratio of fuel to oil. CHAIN AND BAR LUBRICATION Always refill the chain oil tank each time the fuel tank is refilled. We recommend using Genuine Factory Parts Chain, Bar and Sprocket Oil, which contains additives to reduce friction and wear and to assist in the prevention of pitch formation on the bar and chain. TO START ENGINE Press red STOP switch to the “I” ON position for starting (Figure 5-2A). Pull the choke (A) out as far as it will go until the choke stays out. This advances the throttle so you do not have to hold trigger while starting. Push the primer bulb (B) 10 times (Figure 5-2C). NOTE: This saw has the Spring Assist Starting™ system. Spring Assist Starting™ requires much less pulling effort than units without it. MIXING FUEL Mix fuel with Genuine Factory Parts brand 2 cycle oil in an approved container. Use mixing table for correct ratio of fuel to oil. CHAIN AND BAR LUBRICATION Always refill the chain oil tank each time the fuel tank is refilled. We recommend using Genuine Factory Parts Chain, Bar and Sprocket Oil, which contains additives to reduce friction and wear and to assist in the prevention of pitch formation on the bar and chain. TO START ENGINE Press red STOP switch to the “I” ON position for starting (Figure 5-2A). Pull the choke (A) out as far as it will go until the choke stays out. This advances the throttle so you do not have to hold trigger while starting. Push the primer bulb (B) 10 times (Figure 5-2C). NOTE: This saw has the Spring Assist Starting™ system. Spring Assist Starting™ requires much less pulling effort than units without it. After pulling rope 4 times, move choke lever (G) all the way in (Figure 5-2E). [. . . ] How State Law Relates to this Warranty: This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. MANUEL IMPORTANT P/N 9096-310812 IMPRIMÉ AUX TAÏWAN À NE PAS JETER MANUFACTURER’S LIMITED WARRANTY FOR: The limited warranty set forth below is given by Troy-Bilt LLC with respect to new merchandise purchased and used in the United States, its possessions and territories. Troy-Bilt LLC warrants this product against defects in material and workmanship for a period of one (1) year commencing on the date of original purchase and will, at its option, repair or replace, free of charge, any part found to be defective in material or workmanship. This limited warranty shall only apply if this product has been operated and maintained in accordance with the Operator’s Manual furnished with the product, and has not been subject to misuse, abuse, commercial use, neglect, accident, improper maintenance, alteration, vandalism, theft, fire, water or damage because of other peril or natural disaster. [. . . ]