User manual MTD SC3222ESJ

[. . . ] 1-800-520-5520 Made in Taiwan / Hecho en Taiwan • • • • • SAFETY ASSEMBLY OPERATION MAINTENANCE PARTS LIST P/N 9096-MD1802 PRINTED IN TAIWAN TABLE OF CONTENTS Warranty Safety Rules Oil and Fuel information Assembly Starting / Stopping instrustion Page 2 Operation Maintenance Troubleshooting Specifications Parts List Page 12 Pages 13 - 15 Page Page Page 16 17 18 RULES FOR SAFE OPERATION The purpose of safety symbols is to attract your attention to possible dangers. The safety symbols, and their explanations, deserve your careful attention and understanding. The safety warnings do not by themselves eliminate any danger. The instructions or warnings they give are not substitutes for proper accident prevention measures. [. . . ] Always stop the engine and allow it to cool before filling the fuel tank. Keep sparks and open flames at a distance from the area. 2 WARNING: WARNING: CAUTION: Remove fuel cap slowly to avoid injury from fuel spray. Never operate the unit without the fuel cap securely in place. Add fuel in a clean, well ventilated outdoor area. Do not start the engine until fuel vapors dissipate. ATTACH OPERATING TUBE NOTE: keep the throttle cable as straight as possible when connecting the blower tubes. Place the unit on flat surface during assembly. Insure screw mechanism of clamp is positioned away from operator. Put the hose clamp (C) on the flex tube and the operating tube before connecting them together. Turn the throttle linkage mark (D) so it aligns with the throttle handle (F) (Fig. Once adjustments have been made, to the straps for user comfort, remove the blower from your back and place on level ground in an upright position. 13 STARTING/STOPPING INSTRUCTIONS STARTING A COLD ENGINE (Above 55˚F) Mix the bottle of 2-cycle oil (included) with 1 gallon of unleaded gasoline (less than 30 days old). Combine them in a separate container using a 40:1 ratio. Squeeze throttle (A) and push throttle lock (B) to advance throttle for starting. With the unit on the ground, hold the top assist handle and step on the bottom of the frame with foot. ) your blower may need a slight adjustment to the idle speed. After warm up, If unit does not Idle after restarting 2 times, follow these steps to adjust idle. Locate the idle adjustment screw (E) on the carburetor (Figure 16). Using a Phillips or slotted screwdriver - turn screw 1/4 to 1/2 turn clockwise (to the right). When it is necessary to stop blower engine immediately, DEPRESS the OFF “STOP ” switch until the engine stops completely (Figure 9). For normal stopping, release trigger and allow engine to return to idle speed. [. . . ] The manufacturer is not liable to cover failures of warranted parts caused by the use of add-on or modified parts. € In order to file a claim, go to your nearest authorized Troy Bilt Service Center. warranty service or repairs will be provided at all authorized Troy Bilt Service Centers. € Any manufacturer approved replacement part may be used in the performance of any warranty maintenance or repair of emission related parts and will be provided without charge to the owner. [. . . ]