User manual MTD TB10CS

[. . . ] Operator’s Manual Easy Star TM M 2-Cycle Gasoline Trimmer Model TB10CS IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLY P/N 769-01900 (6/05) INTRODUCTION THANK YOU Thank you for buying this quality product. This modern outdoor power tool will provide many hours of useful service. You will find it to be a great labor-saving device. This operator’s manual provides you with easy-tounderstand operating instructions. [. . . ] To release more line, lightly tap the cutting attachment on the ground (Fig. 10) while operating the trimmer at high speed. NOTE: Always keep the trimming line fully extended. Line release becomes more difficult when the cutting line gets shorter. dECORATIVE TRIMMING Decorative trimming is accomplished by removing all vegetation around trees , posts , fences and more. Rotate the whole unit so that the cutting attachment is at a 30° angle to the ground (Fig. 10 Each time the head is bumped, about 1 inch (25. A blade in the cutting attachment shield will cut the line to the proper length if any excess line is released. For best results, tap the bump knob on bare ground or hard soil. If you attempt a line release in tall grass, the engine may stall. Always keep the trimming line fully extended. Line release becomes more difficult when the cutting line gets shorter. 11 OPERATING INSTRUCTIONS USING THE EDGER TO TRIM EDGES To properly use the edge guide to trim edges between lawns and sidewalks or other surfaces, follow these instructions: 1. Make sure the unit is turned completely off. Adjust the D-handle: a) Loosen the wing nut that holds the D-handle to the shaft. Refer to Adjust and Install the D-handle for specific information. B) Rotate the D-handle 90˚ to the right (when facing the unit away from the engine). When you are done using the edger, move it out of the way. Loosen its wing nut and rotate the edger 180˚ from it the position shown in Figure 13. The edger will rest above the cutting attachment guard. Re-tighten the wing nut and operate the trimmer normally. Accomplish this by loosening its wing nut slightly and turning the guide to the left (when facing the unit away from the engine). [. . . ] Any replacement part that is equivalent in performance or durability may be used in non-warranty maintenance or repair and will not reduce the warranty obligations of the manufacturer • The following components are included in the emission related warranty of the engine, air filter, carburetor, primer, fuel lines, fuel pick up/ fuel filter, ignition module, spark plug and muffler. 19 MANUFACTURER’S LIMITED WARRANTY FOR: The limited warranty set forth below is given by Troy-Bilt LLC with respect to new merchandise purchased and used in the United States, its possessions and territories. Troy-Bilt LLC warrants this product against defects in material and workmanship for a period of two (2) years commencing on the date of original purchase and will, at its option, repair or replace, free of charge, any part found to be defective in material or workmanship. This limited warranty shall only apply if this product has been operated and maintained in accordance with the Operator’s Manual furnished with the product, and has not been subject to misuse, abuse, commercial use, neglect, accident, improper maintenance, alteration, vandalism, theft, fire, water or damage because of other peril or natural disaster. [. . . ]