User manual MTD TB250

[. . . ] Operator’s Manual 2-Cycle Gasoline Blower Model TB250B SAVE THESE INSTRUCTIONS P/N 769-01169 (4/04) PRINTED IN USA DO NOT THROW AWAY INTRODUCTION THANK YOU Thank you for buying this quality product. This modern outdoor power tool will provide many hours of useful service. You will find it to be a great labor-saving device. This operator’s manual provides you with easy-tounderstand operating instructions. [. . . ] Always stop the engine and allow it to cool before filling the fuel tank. Keep sparks and open flames at a distance from the area. WARNING: engine CAUTION: For properand operation maximum reliability, pay strict attention to the oil and fuel mixing instructions on the 2-cycle oil container. Using improperly mixed fuel can severely damage the engine. Remove fuel cap slowly to avoid injury from fuel spray. Never operate the unit without the fuel cap securely in place. WARNING: WARNING: Add fuel in a clean, well ventilated outdoor area. Do not start the engine until fuel vapors dissipate. nOTE: Dispose of the old fuel/oil mix in accordance to Federal , State and Local regulations. 8 STARTING/STOPPING INSTRUCTIONS WARNING: WARNING: Operate this unit only in a well- ventilated outdoor area. Make sure you are in the starting position when pulling the starter rope (Fig. To avoid serious injury, the operator and unit must be in a stable position while starting. Do not set unit on any surface except a clean, hard area while starting. Debris such as gravel, sand, dust and grass could be picked up by the air intake and thrown out by the discharge opening. This could damage the unit, property, or cause serious injury to bystanders or the operator. Fully press and release the primer bulb 10 times, slowly. Some amount of fuel should be visible in the primer bulb (Fig. If you can’t see fuel in the bulb, press and release the bulb as many times as it takes before you can see fuel in it. Place the unit in the starting position (Fig. Move the throttle control to the fast position ( ) (Fig. Pull the starter rope briskly 1 to 6 times to start the engine. Allow the engine to warm up for 15 to 30 seconds. [. . . ] Any replacement part that is equivalent in performance or durability may be used in non-warranty maintenance or repair and will not reduce the warranty obligations of the manufacturer • The following components are included in the emission related warranty of the engine, air filter, carburetor, primer, fuel lines, fuel pick up/ fuel filter, ignition module, spark plug and muffler. 17 MANUFACTURER’S LIMITED WARRANTY FOR: The limited warranty set forth below is given by Troy-Bilt LLC with respect to new merchandise purchased and used in the United States, its possessions and territories. Troy-Bilt LLC warrants this product against defects in material and workmanship for a period of two (2) years commencing on the date of original purchase and will, at its option, repair or replace, free of charge, any part found to be defective in material or workmanship. This limited warranty shall only apply if this product has been operated and maintained in accordance with the Operator’s Manual furnished with the product, and has not been subject to misuse, abuse, commercial use, neglect, accident, improper maintenance, alteration, vandalism, theft, fire, water or damage because of other peril or natural disaster. [. . . ]