User manual MTD TB25BP

[. . . ] Operator’s Manual 2-Cycle STOP ALTO GAS BACKPACK BLOWER Model TB25BP For problems or questions, DO NOT return this product to the store. Box 361131 Cleveland, OH 44136-0019 For Consumer Assistance Please Call Para La Ayuda Del Consumidor Llame Por Favor CAUTION: Before using this product, read this manual and follow all safety rules and operating instructions. 1-800-520-5520 Made in Taiwan / Hecho en Taiwan • • • • • SAFETY ASSEMBLY OPERATION MAINTENANCE PARTS LIST P/N 9096-MD1802 PRINTED IN TAIWAN Operator’s Manual 2-Cycle STOP ALTO GAS BACKPACK BLOWER Model TB25BP For problems or questions, DO NOT return this product to the store. Box 361131 Cleveland, OH 44136-0019 For Consumer Assistance Please Call Para La Ayuda Del Consumidor Llame Por Favor CAUTION: Before using this product, read this manual and follow all safety rules and operating instructions. [. . . ] Attached throttle linkage clips (# 24-know your blower) - to both ends of the flex tube to secure the throttle cable. 5 For proper engine operation and maximum reliability, pay strict attention to the oil and fuel mixing instructions on the 2-cycle oil container. Using improperly mixed fuel can severely damage the engine. 8 9 ASSEMBLY INSTRUCTIONS ATTACH INTERMEDIATE TUBE AND CONCENTRATOR NOZZLE Connect the intermediate tube (H) and concentrator nozzle (I) or 56mm nozzle (J) (you can only use I nozzle at time). Push the tubes together and turn them clockwise so that they lock together (Fig. Use concentrator nozzle when you need more airflow in tight places: flower beds, under decks, etc. STARTING/STOPPING INSTRUCTIONS NOTE: The unit uses the Spring AssistTM starting system, which significantly reduces the effort required to start the engine. You must pull the starter rope out far enough to hear the engine attempt to start. There is no need to pull the rope briskly--there is no harsh resistance when pulling. Be aware that this starting method is vastly different from (and much easier than) what you may be used to. Squeeze throttle and release to disengage lock ; Unit is now at idle. 9) NOTE: If engine fails to start after repeated attempts, refer to Troubleshooting section. NOTE: Always pull starter rope straight out. pulling starter at an angle will cause rope to rub against the eyelet. This friction will cause the rope to fray and wear more quickly. Always hold starter handle when rope retracts. Never allow rope to snap back from extended position. This could cause rope to snag or fray and also damage the starter assembly. ADJUST BACK PACK HARNESS AND CONTROL HANDLE Place blower on your back by slipping arms through the shoulder straps as if you were putting on a jacket (Figure 8). adjust backpack harness and control handle. Once adjustments have been made, to the straps for user comfort, remove the blower from your back and place on level ground in an upright position. 13 STARTING/STOPPING INSTRUCTIONS STARTING A COLD ENGINE (Above 55˚F) Mix the bottle of 2-cycle oil (included) with 1 gallon of unleaded gasoline (less than 30 days old). [. . . ] Any replacement part that is equivalent in performance or durability may be used in non-warranty maintenance or repair and will not reduce the warranty obligations of the manufacturer. € The following components are included in the emission related warranty: engine, air filter, carburetor, primer, fuel lines, fuel pick up/fuel filter, ignition module, spark plug and muffler. 5-13 6032-150-02 Description WASHER NUT SCREW HOUSING SCREW SCREW COVER SCREW FRAME WASHER NUT CUSHION BACK RIVET RIBBED HARNESS NUT WASHER SCREW ELBOW PIPE1 HOSE BEND WIRE CLAMP FLEX PIPE ACTIVE RING BASE PIPE MIDDLE PIPE END PIPE END PIPE THROTTLE LEVER ASS'Y WASHER LIGATE TAPE 18 MANUFACTURER’S LIMITED WARRANTY FOR: Manuel del Dueño/Operador The limited warranty set forth below is given by Troy-Bilt LLC with respect to new merchandise purc hased and used in the United States, its possessions and territories. Troy-Bilt LLC warrants this product against defects in material and workmanship for a period of two (2) years commencing on the date of original purchase and will, at its option, repair or replace, free of charge, any part found to be defective in material or workmanship. [. . . ]