User manual MTD TB4018CC

[. . . ] Operator’s Manual STOP ARRÊT ALTO 2-Cycle Gas Chain saw For problems or questions, DO NOT return this product to the store. Hold chain saw firmly with both hands when using. For your own safety, please read and follow the safety precautions in this manual before attempting to operate your chain saw. SAVE THESE INSTRUCTIONS P/N 9096-310812 PRINTED IN TAIWAN DO NOT THROW AWAY INTRODUCTION THANK YOU Thank you for buying this quality product. [. . . ] This will cause permanent engine damage and void the manufacturer’s warranty for that product. Never use a fuel mixture that has been stored for over 90 days. If 2-cycle lubricant other than Genuine Factory Parts Custom Lubricant is to be used, it must be a premium grade oil for 2-cycle air cooled engines mixed at a 40:1 ratio. Do not use any 2-cycle oil product with a recommended mixing ratio of 100:1. If insufficient lubrication is the cause of engine damage, it voids the manufacturer’s engine warranty for that occurrence. ENGINE PRE-START CHECKS FUEL MIXING TABLE WARNING Never start or operate the saw unless the bar and chain are properly installed. Fill the fuel tank (A-red cap) with correct fuel mixture (Figure 5-1A). Fill the oil tank (B-black cap) with correct chain and bar oil (Figure 5-1A). Be certain the CHAIN BRAKE® is disengaged (C) before starting unit (Figure 5-1A). RECOMMENDED FUELS Some conventional gasolines are being blended with oxygenates such as alcohol or an ether compound to meet clean air standards. Your McCulloch engine is designed to operate satisfactorily on any gasoline intended for automotive use including oxygenated gasolines. MIXING FUEL Mix fuel with Genuine Factory Parts brand 2 cycle oil in an approved container. Use mixing table for correct ratio of fuel to oil. CHAIN AND BAR LUBRICATION Always refill the chain oil tank each time the fuel tank is refilled. We recommend using Genuine Factory Parts Chain, Bar and Sprocket Oil, which contains additives to reduce friction and wear and to assist in the prevention of pitch formation on the bar and chain. TO START ENGINE Press red STOP switch to the “I” ON position for starting (Figure 5-2A). Pull the choke (A) out as far as it will go until the choke stays out. This advances the throttle so you do not have to hold trigger while starting. Push the primer bulb (B) 10 times (Figure 5-2C). NOTE: This saw has the Spring Assist Starting™ system. Spring Assist Starting™ requires much less pulling effort than units without it. After pulling rope 4 times, move choke lever (G) all the way in (Figure 5-2E). [. . . ] Damage resulting from the installation or use of any accessory or attachment not approved by Troy-Bilt LLC for use with the product(s) covered by this manual will void your warranty as to any resulting damage. This warranty is limited to ninety (90) days from the date of original retail purchase for any Troy-Bilt product that is used for rental or commercial purposes, or any other income-producing purpose. hOW TO OBTAIN SERVICE: Warranty service is available , WITH PROOF OF PURCHASE THROUGH YOUR LOCAL AUTHORIZED SERVICE DEALER. To locate the dealer in your area, visit our website at www. [. . . ]