User manual MTD TB525ET

[. . . ] Operator’s Manual 4-Cycle Gasoline Trimmer/Edger TB525ET SAVE THESE INSTRUCTIONS For service call 1-800-828-5500 in the United States, or 1-800-668-1238 in Canada to obtain a list of authorized service dealers near you. For more details about your unit, visit our website at www. Service on this unit both within and after the warranty period should be performed only by an authorized and approved service dealer. E20 All information, illustrations, and specifications in this manual are based on the latest product information available at the time of printing. [. . . ] As the blade wears, it becomes smaller, reducing the cutting depth performance. depth Adjustment Knob Raise Depth Fig. 17 HOLDING THE UNIT WITH EDGER ADD-ON WARNING: Always wear eye, hearing, foot and body protection to reduce the risk of injury when operating this unit. Before operating the unit as an edger, stand in the operating position (Fig. Check for the following: • The operator is wearing eye protection and proper clothing • With a slightly-bent right arm, the operator’s hand is holding the shaft grip • The operator’s left arm is straight, the left hand holding the J-handle • The unit is at waist level • The edger wheel is adjusted for proper cut depth and the edger is positioned as shown in Fig. Loosen the adjustment knob above the wheel (Fig 19). Slide the wheel to the desired position: • Raising the wheel increases the cutting depth • Lowering the wheel decreases the cutting depth 3. Use it to hang up the edger, cutting attachment, or other add-on out of the way when not in use. Push the release button on the shaft housing and pull the hanger to remove. Align the hole in the hanger with the release button on the shaft housing and push on to install. 18 10 MAINTENANCE AND REPAIR INSTRUCTIONS MAINTENANCE SCHEDULE Perform these required maintenance procedures at the frequency stated in the table. These procedures should also be a part of any seasonal tune-up. NOTE: Some maintenance procedures may require special tools or skills. If you are unsure about these procedures take your unit to any non-road engine repair establishment, individual or authorized service dealer. NOTE: Maintenance, replacement, or repair of the emission control devices and system may be performed by any non-road engine repair establishment, individual or authorized service dealer. In order to assure peak performance of your engine, inspection of the engine exhaust port may be necessary after 50 hours of operation. If you notice lost RPM, poor performance or general lack of acceleration, this service may be required. If you feel your engine is in need of this inspection, refer service to any non-road engine repair establishment, individual or authorized service dealer for repair. DO NOT attempt to perform this process yourself as engine damage may result from contaminants involved in the cleaning process for the port. WARNING: To prevent serious injury, never perform maintenance or repairs with unit running. Disconnect the spark plug wire to ensure that the unit cannot start. FREQUENCY Before starting engine Every 10 hours 1st change at 10 hours 2nd change at 25 hours Every 25 hours after 10 hours on new engine Every 25 hours Every 25 hours MAINTENANCE REQUIRED Fill fuel tank with fresh fuel Check oil Clean and re-oil air filter Change oil Change oil Clean spark arrestor SEE p. [. . . ] This limited warranty shall only apply if this product has been operated and maintained in accordance with the Operator’s Manual furnished with the product, and has not been subject to misuse, abuse, commercial use, neglect, accident, improper maintenance, alteration, vandalism, theft, fire, water or damage because of other peril or natural disaster. Damage resulting from the installation or use of any accessory or attachment not approved by Troy-Bilt for use with the product(s) covered by this manual will void your warranty as to any resulting damage. This warranty is limited to ninety (90) days from the date of original retail purchase for any Troy-Bilt product that is used for rental or commercial purposes, or any other income-producing purpose. hOW TO OBTAIN SERVICE: Warranty service is available , WITH PROOF OF PURCHASE THROUGH YOUR LOCAL AUTHORIZED SERVICE DEALER. [. . . ]