User manual MTD YM

[. . . ] English Operator’s Manual Gas Trimmer Model MCT33360E IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLY P/N 9096-333606 © 2004 PRINTED IN CHINA INTRODUCTION THANK YOU Thank you for buying this quality product. This modern outdoor power tool will provide many hours of useful service. You will find it to be a great labor-saving device. This operator’s manual provides you with easy-tounderstand operating instructions. [. . . ] Using Blended Fuels If you choose to use a blended fuel, or its use is unavoidable, follow recommended precautions: • Always use the fresh fuel mix explained in your operator's manual • Always agitate the fuel mix before fueling the unit • Drain the tank and run the engine dry before storing the unit UNLEADED GAS 1 GALLON US (3. (95 ml) 25 ml Using Fuel Additives The bottle of 2-cycle oil that came with your unit contains a fuel additive which will help inhibit corrosion and minimize the formation of gum deposits. It is recommended that you use our 2-cycle oil with this unit. If unavailable, use a good 2-cycle oil designed for air-cooled engines along with a fuel additive, such as STA-BIL® Gas Stabilizer or an equivalent. ) of fuel additive per gallon of fuel according to the instructions on the container. Always stop the engine and allow it to cool before filling the fuel tank. Keep sparks and open flames at a distance from the area. WARNING: engine CAUTION: For properand maxioperation mum reliability, pay strict attention to the oil and fuel mixing instructions on the 2-cycle oil container. Using improperly mixed fuel can severely damage the engine. NOTE: If your engine is damaged from insufficient lubrication, it voids the manufacturer’s warranty. Straight gasoline in the unit also voids the warranty. Remove fuel cap slowly to avoid injury from fuel spray. Never operate the unit without the fuel cap securely in place. WARNING: WARNING: Add fuel in a clean, well ventilated outdoor area. Do not start the engine until fuel vapors dissipate. nOTE: Dispose of the old fuel/oil mix in accordance to Federal , State and Local regulations. 8 STARTING/STOPPING INSTRUCTIONS STARTING A COLD ENGINE Operate this unit only in a well- ventilated outdoor area. carbon monoxide exhaust fumes can be lethal in a confined area. NOTE: To minimize the load on the engine during starting and warm-up, trim any excess trimming line. Leave about 5 inches (13 cm) of line from the cutting attachment (Fig. Move the ignition switch to the Run position (Fig. Prime the carburetor by fully pressing and releasing the primer bulb 10 times (Fig. [. . . ] This limited warranty shall only apply if this product has been operated and maintained in accordance with the Operator’s Manual furnished with the product, and has not been subject to misuse, abuse, commercial use, neglect, accident, improper maintenance, alteration, vandalism, theft, fire, water or damage because of other peril or natural disaster. Damage resulting from the installation or use of any accessory or attachment not approved by MTD for use with the product(s) covered by this manual will void your warranty as to any resulting damage. This warranty is limited to ninety (90) days from the date of original retail purchase for any MTD product that is used for rental or commercial purposes, or any other income-producing purpose. hOW TO OBTAIN SERVICE: Warranty service is available , WITH PROOF OF PURCHASE THROUGH YOUR LOCAL AUTHORIZED SERVICE DEALER. [. . . ]