User manual MULTICOAT BLUE LINE METAL LATHE WATERPROOF SYSTEM

[. . . ] ( KRETE KOTE 2000 or TOP COAT 2000) The METAL LATHE WATERPROOF SYSTEM is designed to withstand heavy foot traffic on decks, ramps, walkways, etc. The METAL LATHE WATERPROOF SYSTEM can be applied to concrete, wood, magnesite and most other surfaces or substrates in need of a waterproofing and/or fire resistant protective coating. Staple metal lathe to deck MULTI-BASE applied, covering wire lathe ADVANTAGES · · · · · · · · · Low Cost - Minimum Down Time - Easy to Apply Superior Waterproofing Hard, Durable, Anti-Skid Surface Maintains Surface Integrity Over Minor Substrate Movement Excellent Weather-Salt-Fire Resistance Superior Bonding to Substrate Excellent Freeze-Thaw Resistance High Impact and Abrasion Resistance Water base - Environmentally Safe to Use and Apply MULASTICOAT applied SEE TEST DATA SURFACE PREPARATION All substrates must be structurally sound, free from all grease, oil, paint, dirt, dust, sealers, curing compounds, and other foreign materials which may prevent proper bonding. [. . . ] DO NOT ALLOW MULASTICOAT® TO BE EXPOSED DIRECTLY TO THE SUN FOR MORE THAN 3 DAYS. KRETE KOTE and TOP COAT 2000 are furnished in 65 lb. bags and field mixed with potable (clean) water in the approximate amount of 1¾-2 gallons per bag. Mix vigorously to disperse all lumps and to thoroughly wet all particles. Use a margin trowel to clear vessel sides. Adjust to desired consistency by addition of dry material or small amount of water. For best results let KRETE KOTE or TOP COAT stand in the bucket for 3-5 minutes, then add a small amount of water and rebreak material. Mixed KRETE KOTE and TOP COAT 2000 are applied by roller, trowel, or squeegee in one coat plus texture coat, or two or more coats plus texture coat, depending on surface conditions. Not responsible for cracks and delamination caused by structural movement, improper substrate or application SEE WARRANTY. ACRATHANE COLORSEAL(RECOMMENDED) Apply two coats of COLORSEAL (Refer to COLORSEAL "Instructions for use. ") Allow minimum 24 hour cure before allowing foot traffic and minimum 72 hours before allowing vehicle traffic. Masonry patterns available with MULTI-STAIN. COVERAGE MULTI-BASE 65-75 sf. ft per bag (1-2 coats) MULASTICOAT (waterproofing membrane): 40 to 50 sq. (See "PACKAGING AND STORAGE") COLORSEAL 150 - 200 sq. per gallon (2 coats). LIMITATIONS Do not apply any components of the SLATEX SYSTEM when substrate surface temperature is below 50°F, above 100°F, if ambient temperature is below 50°F and falling, over 100°F and expected to rise, or if precipitation is expected within a 24 hour period. PACKAGING AND STORAGE MULASTICOAT - furnished in 1 and 5 gallon containers, 55 gallon drums and 275 gallon totes. [. . . ] . . . . . . . . . . . . . . . . . . . . . ASTM D2299 To most Chemicals and Solvents 8. . . . . . . . . . . . . . . . . . ASTM C67 PLYWOOD CONCRETE Bond Strength . [. . . ]