User manual MULTICOAT SLATEX BELOW GRADE

[. . . ] SLATEX BELOW GRADE COLORSEAL is designed for application to Multicoat KRETE KOTE, TOP COAT, and other cementitious surfaces. [. . . ] Multicoat KRETE KOTE and TOP COAT must be allowed to set up and cure for at least 24 to 48 hours before COLORSEAL application. New concrete should be allowed to cure for a minimum of 20 days, and be free from curing compounds, release agents if any, and other water repellent materials which may prevent proper bonding. APPLICATION Multicoat COLORSEALS must be applied in two thin coats. First Coat - Mix COLORSEAL to uniformity with slow speed mixer. With continuous mixing, add clean water in ratio of 1 part water to 3 parts COLORSEAL. Seller makes no other warranty, expressed or implied, regarding the use of its products. Since use of the product is beyond the Seller's control, the Buyer assumes all risks of use. Seller's sole obligation shall be to replace material if found to be defective. Seller shall not be liable for any damages, injury, loss, direct or consequential, resulting from use of its products. LIMITATIONS Do not apply if surface temperature is less than 50°F. , over 100°F. , ambient temperature is less than 50°F and falling, over 100°F and rising, or if precipitation is expected within a 24 hour period. PACKAGING AND STORAGE Furnished in one (1) and five (5) gallon containers. [. . . ] Shelf life - approximately 9 months in unopened containers. M TICO UL MULTICOAT CORPORATION West Coast Toll Free: (877) MULTICO (685-8426) (949) 888-7100 FAX (949) 888-2555 website: www. multicoat. com E-mail: multi5000@aol. com MULTICOAT PRODUCTS, INC. [. . . ]