User manual MURRAY 425618X51

[. . . ] CAUTION, when used without the alert symbol, indicates a situation that could result in damage to the equipment. Figures (Example: Figure 1) are located on the inside front and back pages of this manual located before the parts list. This instruction book is written for a person with some mechanical ability. Like most service books, not all the steps are described. [. . . ] Read this Instruction Book and safety rules before operation the snow thrower. Compare the illustration with your snow thrower to familiarize yourself with the location of various controls and adjustments. WARNING: Always stop the engine before unclogging the discharge chute or the auger housing and before leaving the snow thrower. (Figure 13) Push the remote chute lever (2) forward to discharge the snow high and far. Pull the remote chute lever (2) back to discharge the snow down. Make sure the height adjust skids are properly adjusted. The correct air pressure is 14 PSI (1 BAR) to 17 PSI (1. Do not exceed the maximum amount of air pressure shown on the side of the tire. (Electric Start) Connect the power cord to the switch box (11) located on the engine. (Electric Start) Plug the other end of the power cord into a three-hole, grounded 220 VOLT, A. Every time you push the primer button (9), wait two seconds. CAUTION: To stop the engine, do not move the choke control to CHOKE position. Models equipped with an Electric Starter NOTE: An electric starter kit can be added to recoil start engines. Electric starter kits are available from your nearest authorized service center. WARNING: The starter is equipped with a three-wire power cord and plug and is designed to operate on 220 volt A. The power cord must be properly grounded at all times to avoid the possibility of electrical shock which can injure the operator. carefully follow all instructions in the "How To Start The Engine" section. Make sure that your house wiring is a three-wire grounded system. If you are not sure, ask a licensed electrician. If your house wire system is not a three-wire grounded system, do not use this electric starter under any conditions. If your system is grounded but a three-hole grounded receptacle is not available to start the engine, have a three-hole grounded receptacle installed by a licensed electrician. Power cord, always connect the power cord to the switch box (11) on the engine first. [. . . ] The replacement parts are shown either on the back pages of this Instruction Book or in a separate Parts List Book. use only manufacturer's authorized or approved replacement parts. Do not use attachments or accessories not specifically recommended for this unit. In order to obtain proper replacement parts you must supply the model number (see nameplate). [. . . ]