User manual MURRAY 6210701X61

[. . . ] This warranty is effective for the time periods and subject to the conditions stated below. for warranty service , find the nearest Authorized Service Dealer in your area. For warranty service, find the nearest Authorized Service Dealer in our dealer locator map at www. Some states or countries do not allow limitations on how long an implied warranty lasts, and some states or countries do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation and exclusion may not apply to you. [. . . ] Slide the seat (1) forward or backward along the seat adjusting holes (3). Before you leave the operator's position, make sure the blade(s) has stopped rotating. Before you ride the unit across a sidewalk or a road, move the blade rotation control (1) to the DISENGAGE position. WARNING: Always keep your hands and feet away from the blade, deflector opening, and the mower housing when the engine runs. To stop the engine, turn the ignition key (3) to the OFF position. To use the lights with the engine running, turn the key to the position for the lights. To change the forward speed or the direction of the unit, follow the steps below. CAUTION: Before you move the shift lever, completely push the clutch/brake pedal forward to stop the unit. If the unit is not stopped, the gearbox can be damaged. Completely push the clutch/brake pedal (2) forward to stop the unit. To go forward, move the shift lever (4) to a forward speed setting. After one or two rounds, mow in the opposite direction making left turns until finished. If the grass is very high, cut two times to decrease the load on the engine. First cut with the mower housing in the highest position and then lower the mower housing for the second cut. For better engine performance and an even discharge of the cut grass, always operate the engine with the throttle in FAST position. When you use a bagger, operate the engine with the throttle in FAST position and the shift lever in first or second gear. For better cutting performance and a quality cut, mow with the shift lever in one of the slower speeds. After each use, clean the bottom and top of the mower housing for better performance. These components tell the electrical system if the operator is sitting on the seat. This system will stop the engine when the operator leaves the seat. For your protection, always make sure this system operates correctly. NOTE: The engine will not start unless you depress the clutch/brake pedal and move the blade rotation control to the DISENGAGE position. [. . . ] Remove the hair pins and the washers from the adjuster arms (3). Remove the hair pins and washers from the suspension links (4). Follow the steps, "How To Start The Engine" in this book. Turn the ignition key to the ON position. [. . . ]