User manual NAD 319

[. . . ] Warning: To reduce the risk of fire or electric shock, do not expose this unit to rain or moisture. The lightning flash with an arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shcok to persons. If an indoor antenna is used (either built into the set or installed separately), never allow any part of the antenna to touch the metal parts of other electrical appliances such as a lamp, TV set etc. Any outdoor antenna must be located away from all power lines. [. . . ] The NAD 319 only accepts analogue signals from your CD player. Input for the audio signal from a stereo VCR (or stereo TV/Satellite/Cable receiver) or other line-level audio source. Using twin RCA-to-RCA leads, connect to the left and right `Audio Out' of the unit to these inputs. The NAD-Link connector is used to pass commands from the remote control handset to and from other units fitted with NAD-Link connectors. This allows centralised control of a complete system or gives system control from more than one room. To function with other units, connect the NAD 319's NAD-Link OUT to the NAD-Link IN on the other unit. NAD-Link connectors can be daisy-chained, IN to OUT, so that a whole system can be controlled from the remote control facilities of one unit. A single NAD-Link connection from a hi-fi system in a second room will allow remote control of Multi Room systems. Use a twin RCA-to-RCA lead to connect the Tuner left and right `Audio Outputs' to this input. Always use heavy duty (16 gauge or thicker) stranded wire to connect loudspeakers to your NAD 319. The high-current binding post terminals can be used as a screw terminal for cables terminating in spade or pin connectors or for cables with bare wire ends. SPADE CONNECTORS These should be slotted under the terminal's screw bushing, which is then fully tightened. Ensure the connector is tightly secured and there is no danger of bare metal from spade connectors touching the back panel or another connector, as this may cause damage. BARE WIRES AND PIN CONNECTORS Bare wires and pin connectors should be inserted into the hole in the shaft of the terminal. Unscrew the speaker terminal's plastic bushing until the hole in the screw shaft is revealed. Insert the pin or bare cable end into the hole and secure the cable by tightening down the terminal's bushing. Avoid any danger of bare metal from the speaker cables touching the back panel or another connector. Ensure that there is only 1/2" (1cm) of bare cable or pin and no loose strands of speaker wire. So speakers with very low impedances (under 4 ) are not recommended as they may cause the amplifier's thermal cut-out to operate if played at high levels. The Bridge LED on the front panel will illuminate when the amplifier is in Bridge mode. After you complete all connections to the preamplifier, plug the AC line cord into a "live" AC socket. The AC power cords of other units in the audio system can be connected directly to the 319's unswitched AC outlets. [. . . ] Two AA (R6) batteries should be fitted in the battery compartment at the rear of the Remote Control handset. When replacing batteries, check that they have been put in the right way round, as indicated on the base of the battery compartment. please refer to previous sections of the manual for a full description of individual functions. Note: The remote control handset supplied is the NAD universal remote and can be used on any remote controllable NAD system. [. . . ]