User manual NAD C 715

[. . . ] ® Owner’s Manual CD Receiver C 715 РУССКИЙ SVENSKA NEDERLANDS DEUTSCH ITALIANO ESPAÑOL FRANÇAIS ENGLISH IMPORTANT SAFETY INSTRUCTIONS ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ 1. Read instructions - All the safety and operating instructions should be read before the product is operated. 2. Retain instructions - The safety and operating instructions should be retained for future reference. 3. Heed Warnings - All warnings on the product and in the operating instructions should be adhered to. 4. Follow Instructions - All operating and use instructions should be followed. [. . . ] When programming a sequence of tracks, the C 715 must be in STOP mode. Using the SR 7 remote control, enter your desired program sequence through the following steps 1 Press [PROGRAM]. The display indicates “P00 T00”. PLAYING MP3/WMA FILES The C 715 can play MP3/WMA formatted recordings on CD-R or CD-RW discs. You may mix any of the file types on the disc. Using the SR 7 remote control, one can select through the MP3/WMA folders and files as well as start playback through the following steps 1 Load the applicable disc. 2 Press [FOLDER ] to select desired folder. Press [ENTER]. 3 Press [FILE playback. ] to select desired file number. Press [ENTER] to start 3 The C715 is now ready for your second program entry. Key-in the second track you desire to program. As in step 2, the track section will keep on blinking until the second digit is entered. As soon as the track number is fully entered, the blinking stops and the program sequence completed. 4 Repeat steps 2 and 3 to select and store other track numbers in memory, up to a maximum of 30 entries. If you attempt to program more than 30 tracks or files, “P-FULL” will be displayed in the VFD. 5 Press [PROGRAM] to end or finalize the program – the VFD will show “P-End”. NOTES • The procedure for programming MP3/WMA files and USB files are the same as above. • At CD mode, the programmed sequence/contents will not be lost even though the C715 is powered OFF (standby) or the SOURCE mode changed. It will only be lost if the disc tray is opened. • To recall the program sequence, press [PROGRAM] and then [ ] to playback the program. NOTES • Access to folders and files can be made at STOP or playback mode. • Information about the Song Title, Album and Artist name, if available, will scroll through the VFD during playback. • The file number is recognized per disc, not per folder – that is, the number assigned to each file corresponds to their sequence in the disc. • If you want to select file number “9” in a disc where there are 100 or more MP3/WMA files, press “0” twice and then “9. ” 11 РУССКИЙ SVENSKA NEDERLANDS DEUTSCH ITALIANO ESPAÑOL 2 Use the Direct-Entry numeric keypad buttons to enter the first track in your planned sequence. For example, to enter track number “1, ” press “0” and then “1”. [. . . ] POSSIBLE SOLUTIONS • Plug the power cord into the wall outlet securely. • Check if AC lead is plugged in and power switched on. • Check connections to all speakers in the system. • Reload the disc with the label side UP. [. . . ]