User manual NAD C 725BEE

[. . . ] ® Owner’s Manual Stereo Receiver C 725BEE РУССКИЙ SVENSKA NEDERLANDS DEUTSCH ITALIANO ESPAÑOL FRANÇAIS ENGLISH IMPORTANT SAFETY INSTRUCTIONS ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ Save these instructions for later use. Follow all warnings and instructions marked on the audio equipment. 1 Read instructions - All the safety and operating instructions should be read before the product is operated. 2 Retain instructions - The safety and operating instructions should be retained for future reference. [. . . ] 19 AM ANTENNA INPUT: Connect the supplied AM loop antenna to these terminals. If an external AM antenna is used, make connections to the AM and GND terminals in accordance with the instructions supplied with the antenna. Refer also to the item ABOUT ANTENNAS at the LISTENING TO AM/FM RADIO section of the OPERATION page. 20 DAB MODULE INPUT PORT (230V version only): Plug-in the other end of the Mini-Din connector from the NAD DAB Adaptor DB 1 module output port into this socket. The C 725BEE is compatible only with NAD DAB Adaptor DB 1 so check with your NAD dealer for this module’s availability. With DAB, you can receive CD-like quality programs without any annoying interference and signal distortion. Refer also to “LISTENING TO DAB RADIO” under the “OPERATION” main heading. 21 AC LINE CORD: Plug the AC power cord into a live AC wall socket. Connect only to the prescribed AC Outlet, i. e. , 120V 60 Hz or 230V 50 Hz. Make sure all connections have been made before connecting to mains. 10 IDENTIFICATION OF CONTROLS REMOTE CONTROL USING THE SR 8 REMOTE CONTROL 1 2 The SR 8 remote control handset handles the key functions of the C 725BEE as well as other NAD Stereo Receivers, Integrated Amplifiers and Preamplifiers. It has additional controls to remotely operate NAD CD Players, AM/FM Tuners and dedicated AM/FM/DAB Tuners. It will operate up to a distance of 23ft (7m). Alkaline batteries are recommended for maximum operating life. Two AAA batteries should be fitted in the battery compartment at the rear of the Remote Control handset. When replacing batteries, check that they have been put in the right way round, as indicated on the base of the battery compartment. When a command from the remote control is received, the Standby LED indicator will blink. Note that the indicator may also blink when receiving commands not necessarily for the C 725BEE but for other components in the system. Please refer to previous sections of the manual for a full description of individual functions. NOTE The remote control handset supplied with the C 725BEE is of a universal NAD type, designed to operate several NAD models. Some buttons are applicable only to specific NAD models. Contact your dealer or NAD audio specialist for assistance. 1 POWER ON & OFF: The SR 8 remote has a separate ON and OFF button. [. . . ] • Batteries are flat or incorrectly inserted. • IR transmitter window on remote or IR receiver window on C 725BEE is obstructed. • C 725BEE front panel is in very bright sunlight or ambient light. POSSIBLE SOLUTIONS • Plug the power cord into the wall outlet securely. [. . . ]