User manual NAD HTR1

[. . . ] SYSTEM REMOTE CONTROL OWNER'S MANUAL HTR-1 GB GB 2 NAD HTR-1 UNIVERSAL REMOTE CONTROL Introduction . . 6 Inserting & replacing batteries & back-up . . 12 GB 3 USING THE NAD HTR-1 UNIVERSAL REMOTE CONTROL WITH THE NAD T761 AV RECEIVER The NAD HTR-1 Universal Remote control packed with your NAD T761 AV receiver has been pre-configured to operate all controls. Besides operating the receiver, the HTR-1 can replace up to eight remote controls for different devices. [. . . ] Example You wish to set up the HTR-1 to operate your Philips TV: 1 Look up the Manufacturer ID code for Philips (which is 3232). 14) together for approximately 2 seconds until STATUS LED (No. 1) stays red. The STATUS LED will change to red again. 3 Using the numeric keys (No. 10); enter 3232 (Philips' Manufacturer ID code). The STATUS LED will flash once (if the code is wrong, the STATUS LED will flash twice). 5 Philips has many different sets of remote commands. In order to find the correct set of remote control commands for your particular model, you will need to search within the Philips' ID code: · Press the POWER ON/OFF key and hold down for 2 seconds then release for 2 seconds, repeat this process until your device switches off (or switches to Stand-by). NB: If you accidentally skipped a code that turned your device off, you can go one code back by pressing the MUTE key. Press the lit DEVICE KEY once and now try out the other function keys on the HTR­1. · You mayfind that not all keys device operate the TV correctly; press the DEVICE Key for 1 second; the DEVICE Key will flash once. The second set that turns off your TV does operate all major functions correctly: Proceed to the next step to store. Press the DEVICE Key 3 times until the DEVICE Key and STATUS LED go out. The code is now stored and the HTR-1 is ready for use with your Philips TV. GB 6 7 8 CODE RECALL FUNCTION The Code Recall function allows you to look up the exact code specific for your device's brand and model. Note this is not the manufacturer IC code, but the specific device code that operates your device; this is a 5-digit number. 14) together for approximately 2 seconds until STATUS LED (No. 1) stays red. Press the required DEVICE key (No. 3); the DEVICE key will light up. 10) engage Code Recall Mode: Press 88881 to check the code for a Tuner. Press 88882 to check the code for an Amp. Press 88883 to check the code for a CD player. Press 88884 to check the code for a DVD player. Press 88886 to check the code for a VCR. Press 88887 to check the code for a Cable or Satellite receiver. [. . . ] The STATUS LED and DEVICE key will go out and the Macro is programmed. NOTE Some devices may not be capable in executing remote commands in rapid succession. When recording your macro, this problem can be avoided by alternating each commands for the various devices, see example below. 10 Example With just pressing Macro for AMP as device, you wish to switch on your AV receiver, TV and DVD player; select the Video 1 input on the receiver and activate Play on the DVD player. 14) together for approximately 2 seconds until STATUS LED (No. 1) stays red. [. . . ]