User manual NAD HTRM

[. . . ] GETTING FAMILIAR WITH THE HTRM The HTRM is divided into three main sections. The LCD display section at the top of the handset, the DEVICE SELECTOR , and the remaining 44 Control keys. (see Figure 1) Eight DEVICE SELECTOR keys at the top; AMP, TV, CUSTOM, CD, DVD, VCR, TUNER, and CABLE/SAT determine which component the remaining 44 control keys will operate. A DEVICE SELECTOR key determines what component the HTRM will command; with factory defaults, it does not perform any function on the receiver. [. . . ] It will then turn off again five seconds after no key has been pressed. The behaviour and timeout for the backlight can be adjusted. (Refer to the "HTRM Features" for further information. ) LOW BATTERY WARNING If the HTRM senses the batteries are low, it will show "Low Batt" on the second line of the LCD display whenever the remote is idle. When this occurs the batteries should be replaced with new ones immediately. DEVICE SELECTOR KEYS Simply pressing a DEVICE SELECTOR key will change the active device on the HTRM. At this time, no IR commands will be transmitted. The name of the selected device will be shown on the first line of the LCD display. Note: Any IR command can be associated with a DEVICE SELECTOR key during "Copy" and "Learn" modes. Once the associated function is assigned to the DEVICE SELECTOR key pressing and holding the DEVICE SELECTOR key for more than two seconds will send the associated command in addition to the HTRM switching its active device. NAVIGATION OF THE HTRM CONTROLS MACRO KEYS A macro can be associated with every key on the HTRM except for the MACRO button itself. To execute a macro: · Press the MACRO key. The first line of the LCD display will show "MACRO". · Within five seconds, press the key the macro is associated with. · While the macro is executing a small "M" will be shown in the top right of the LCD display. (refer to the Setup Menu section for information on how to setup macros) FUNCTION KEYS There are 44 dedicated function keys on the HTRM. When you press a function key, the name of the function will be shown on the second line of the LCD display while the command is being transmitted. A/V PSET KEY In the default configuration of the HTRM, the A/V PSET key acts as a shift function when the AMP device is selected. Pressing the A/V PSET key once will cause "Preset" to be displayed on the first line of the LCD display. If within five seconds you then press a digit 0 - 9, the function for the corresponding A/V Preset will be transmitted. Note: The HTRM is an universal-type remote control, some NAD receivers may not have more than 5 AV presets. SETUP MENU Press and hold the SETUP and ENTER keys for five seconds to enter the Setup Menu. You cannot enter the setup menu if the remote is currently displaying "Low Batt". [. . . ] The second line shows a bar graph representing the reading. · Press the ENTER key to exit this mode. Select "Yes" or "No" to set the new value. USB INTERFACE The HTRM allows one to upload and download the configuration through a Windows PC and NAD's Proprietary HTRM programming software. [. . . ]