User manual NAD IPD 1

[. . . ] The unit may fall, causing serious injury to a child or adult and serious damage to the unit. Use only with a cart, stand, tripod, bracket or table recommended by the manufacturer or sold with the unit. Any mounting of the device on a wall or ceiling should follow the manufacturer's instructions and should use a mounting accessory recommended by the manufacturer. An appliance and cart combination should be moved with care. [. . . ] consult your dealer to have the optional Phono Module fitted. With the S100 Phono Module: Ensure that your dealer has chosen the correct settings inside the Phono Module (MM or MC, cartridge impedance) to suit your specific turntable and cartridge combination. Connect the twin RCA lead from your turntable, observing that the left and right channels are connected correctly. Your S100 should be placed on a firm, level surface. Avoid placing the unit in direct sunlight or near sources of heat and damp. Do not place the unit on a soft surface like a carpet. Do not place it in an enclosed position such as a bookcase or cabinet that may impede the airflow through the ventilation slots. Switch the unit and all ancillary equipment off before making any connections. The RCA connectors on your S100 are colour coded for convenience. Red and white are Right and Left audio respectively, and yellow for NAD-Link. the S100 comes with RCA leads for basic connections. Using twin RCA-to-RCA leads, connect to the left and right `Audio Outputs' of the tape machine to the TAPE 2 IN connectors for playback. CAUTION: When in Standby mode, power is still supplied to your S100. You should switch it Off using the front panel POWER button when it is not being used for long periods of time. Using twin RCA-to-RCA leads, connect to the left and right `Audio Outputs' of the tape machine to the TAPE 1 IN connectors for playback and tape monitoring. LEDs over each button will indicate which input is currently selected. pHONO/AUX 2 Selects the source connected to the PHONO/AUX 2 input. With the optional S100 Phono Module installed, a turntable Phono with either an MM or MC cartridge can be connected. Without the optional Phono Module installed you can use this input for any line-level source. TAPE 1 MONITOR Selects the output from a tape recorder when playing back tapes or monitoring recordings being made through the TAPE 1 sockets. Press the TAPE 1 MONITOR button once to select it and again to return to the normal input selection. TAPE 1 MONITOR is a tape monitor function which does not override the current input selection. [. . . ] Put the source tape in the recorder connected to TAPE 2 and the blank tape into the recorder connected to TAPE 1. By selecting TAPE 2 Input you can now record from TAPE 2 to TAPE 1 and monitor the signal coming from the source tape. Also you can use TAPE 1 as the source and copy to TAPE 2 but TAPE 1 MONITOR Input has to be selected for the duration of the recording. Pressing the POWER button turns the unit On and after a few seconds, the Power indicator LED will extinguish. [. . . ]