User manual NAD L75E

[. . . ] L75 Surround Sound Receiver GB Owner's Manual F D E I P S Manuel d'Installation Bedienungsanleitung Manual del Usuario Manuale delle Istruzioni Manual do Proprietário Bruksanvisning IMPORTANT SAFETY INSTRUCTIONS CAUTION · Read all of these instructions. · Save these instructions for later use. · Follow all warnings and instructions marked on the audio equipment. 1 Read instructions - All the safety and operating instructions should be read before the product is operated. [. . . ] 3 Press the MEMORY button for a while (for more than 1. 5 seconds). a) The start frequency will show in the display: EUR87. 5 MHz in FM, 522 kHz in AM. b) The frequency and display will automatically scan. c) The frequency shown in the display will rapidly change. As each station is located a preset number will appear in the display indicating which preset MEMORY button has been assigned to the station located. The scanning process will continue to operate in this fashion until 30 stations have been found and entered into the preset memory or when there are no more stations to be found on the waveband chosen. The memory indicator will extinguish and let you hear the last station to be memorized. To listen to the memorized station select the band required and press the numeric keys 1, 2, 3 etc. 4 The last memorized preset of each band will be displayed when Auto Memory is completed. Check the programmed frequencies with TUNING/PRESET UP, DOWN button. 2 3 4 1 2 3 4 GB 1 12 RADIO RECEPTION MANUAL MEMORY PRESETTING 1 Select the Tuner by turning the Source selector. 2 Select the AM or FM by pressing the AM/FM selector button. 3 Press the Tune/Preset MODE button to change to TUNING mode. 4 Select the frequency you want to preset by pressing TUNING/PRESET UP or DOWN button. 5 Press the MEMORY button briefly, MEMORY display will blink at an interval of 1 second. 6 While the MEMORY indicator is lit a) Press the TUNING/PRESET button to be desired selection then press the MEMORY button again, or b) Press the numeric keys (on the remote control unit) to input the preset number in which the data for the broadcast is to be stored. DELETING A STORED PRESET You can empty a preset by deleting the stored information 1 Select the preset to be emptied. 2 Press and hold Tune/Preset mode button for more than 4 seconds. The preset will then be deleted and "_ _" appears on the preset number and "DELETED" scrolls on the display. NOTE Empty presets will be skipped during preset tuning. RECALLING FREQUENCIES Press the numeric key(s) corresponding to the channel number to tune directly to a broadcast. "BACK-UP" MEMORY FUNCTION This function conserves the already preset station memories, and "Most-recent" memory function, even in the event of a cut-off of power supply, as when the plug is pulled out of the wall outlet. 2 5 3 4, 6 1 GB 13 RDS (RADIO DATA SYSTEM) RDS is a broadcasting service which allows stations to send additional information along with the regular radio program signal. RDS services can be received only in FM band. [. . . ] Low hum or buzzer sound. Probable Cause Remedy Speakers are connected wrong. After checking, if needed, reconnect. Power line of a fluorescent light is installed near this product. Connect the input cords securely. Place this product as far away as possible from electric devices with interference. After turning off the power and then turning it on again, reduce the volume or change to the correct 8 ohm speakers. Check all speakers for correct polarity. Sound is only heard from one channel. Sound cuts off during listening to the music or no sound even though power is ON. [. . . ]