User manual NAD T 977

[. . . ] NAD and the NAD logo are trademarks of NAD Electronics International, a division of Lenbrook Industries Limited. No part of this publication may be reproduced, stored or transmitted in any form without the written permission of NAD Electronics International. While every effort has been made to ensure the contents are accurate at the time of publication, features and specifications may be subject to change without prior notice. t977_8lang_OM_v01 - Apr 2012 T977_8lang_OM_v01. [. . . ] note suggested speaker connections as reflected in the rear panel channel allocations. 3 Connect your Preamplifier’s PRE OUT to the T 977 rear panel’s INPUT port. note suggested speaker connections as reflected in the rear panel channel allocations. Before connecting the plug to the mains powers source, connect firmly first the other end to T 977’s AC Mains input socket. The T 977 goes to standby mode as shown by the amber status condition of the Standby LED. note suggested speaker connections as reflected in the rear panel channel allocations. Power up your Preamplifier ahead of the T 977. 6 Press STANDBY button to switch ON the T 977 from standby mode. The Standby LED indicator will turn from amber to blue. When the T 977 is switched ON from standby mode, the Channel Status LEDs will initially turn red and then eventually turn blue. 7 Adjust the corresponding T 977 INPUT LEVEL CONTROL and/or Preamplifier’s volume control according to desired listening levels. BARE WIRES AND PIN CONNECTORS WARNING: The terminals marked with this symbol are hazardous live. External wiring connected to these terminals requires installation by an instructed person or the use of ready-made leads or cords. Bare wires and pin sockets should be inserted into the hole in the shaft of the terminal. Unscrew the speaker terminal’s plastic bushing until the hole in the screw shaft is revealed. Insert the pin or bare cable end into the hole and secure the cable by tightening down the terminal’s bushing. Ensure bare wire from the speaker cables does not touch the back panel or another socket. Ensure that there is only 1/2” (1cm) of bare cable or pin and no loose strands of speakers wire. SAVE THE PACKAGING Please save the box and all of the packaging in which your T 977 arrived. Should you move or otherwise need to transport your T 977, this is by far the safest container in which to do so. Have the unit inspected by a qualified service technician before attempting to use it again. 1 STANDBY BUTTON · Press this button to switch ON the T 977. [. . . ] Then, remove all connections from the amplifier. Use a flathead screw driver or similar to open the fuse holder via the slot indicated. With the screw driver in place, push and turn counterclockwise to open the fuse holder. Only replace the fuse with the same type, size, and specification. [. . . ]