User manual NAD T785

[. . . ] ® AV Surround Sound Receiver SVENSKA Owner's Manual Manuel d'Installation Manual del Usuario Manuale delle Istruzioni NEDERLANDS DEUTSCH ITALIANO ESPAÑOL FRANÇAIS ENGLISH T 785 IMPORTANT SAFETY INSTRUCTIONS ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA 1. Readinstructions- All the safety and operating instructions should be read before the product is operated. Retaininstructions- The safety and operating instructions should be retained for future reference. HeedWarnings- All warnings on the product and in the operating instructions should be adhered to. [. . . ] This setting is also used for multi-zone installations using passive "impedance matching" volume controls. See your NAD dealer for specific information about integrating your NAD Receiver into a multi-room audio distribution system. Zone 2 and Zone 3 "Volume" will function the same way as that of Zone 2 when "Mode" is set to "Zone (Audio Only)". See discussion also on "ZONE CONTROLS" at the Main Menu. NOTE TheZR4remotecontrolwillonlycontrolZone2applications. 4 OPERATION USINGTHET785­SETUPMENU AMPLIFIER SETUP If the surround back speakers are not used in the main zone, their surround back amplifier channels could be assigned for Main back, Main Front (Bi-Amp) and multi-zone use. The Surround Back amplifier is configurable through the following settings · MainBack: Assign as surround back speakers. · MainFront(Bi-Amp): Provide a bi-amp mode for the Main Front speakers (Left and Right) speakers thus reproducing the Front Left and Front Right amplifier channel outputs. · Zone2: Assign the surround back amplifier channels to supply Zone 2 speaker level outputs from the surround back speaker terminals. · Zone3: Assign the surround back amplifier channels to supply Zone 3 speaker level outputs from the surround back speaker terminals. · Zone4: Assign the surround back amplifier channels to supply Zone 4 speaker level outputs from the surround back speaker terminals. TRIGGER SETUP TRIGGEROUT Triggers are low voltage signals used to turn on/off other compliant devices. The T 785's three +12V DC Trigger Outputs (Trigger 1 Out, Trigger 2 Out and Trigger 3 Out) are dependent on which mode they are associated with. There are six choices where +12V DC output can be assigned and these are ­ Main, Zone 2, Zone 3, Zone 4, Zone 2+3+4 and Source Setup. Main: +12V DC is available at the assigned Trigger Out when the T 785 is at powered state. Zone2, Zone3, Zone4, Zone2+3+4: When the applicable Zone is at powered state, +1 2V DC is available at the assigned Trigger Out. SourceSetup: If Trigger Output is linked to "Source Setup", +12V DC is available at Trigger Out whenever the particularly assigned Source is selected. Please see also separate discussion about "TRIGGER OUT" under the "SOURCE SETUP (NORMAL VIEW)" section. DELAY The availability of +12V DC at Trigger OUT can be regulated. If it is desired that +12V DC is available without delay the moment Trigger OUT is linked to its assigned setting, set Delay to 0s. Otherwise, one can select through a delay time of 1s to 15s. AUTOTRIGGERIN Auto Trigger IN allows external system controllers to toggle the associated section of the T 785 from "Standby" to "On" and vice versa. When the TRIGGER switch at the rear panel is set to ON, a +12V DC input at Trigger IN will power ON the section where Trigger IN is assigned, Main: From standby mode, the T 785 is powered ON when +12V DC is applied at Trigger IN. Zone 2, Zone 3, Zone 4: Applicable Zone is turned ON whenever +1 2V DC is present at Trigger IN. [. . . ] · Activate Speaker A (or Speaker B) by pressing the corresponding front panel. · Check "Speaker Configuration" menu. · Check power amp, cabling, and speakers. · Select appropriate listening mode. [. . . ]