User manual NADY ACCESS PSS-150

[. . . ] INSPECTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . SETUP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 FRONT PANEL CONTROLS & CONNECTIONS . . . . . . . . . . . . 5 REAR PANEL CONTROLS & CONNECTIONS . . . . . . . . . . . . . . [. . . ] Position the length of the cables so they will not be a safety hazard to people. WARNING: Connect only the supplied speakers to the PSS-150. Never connect additional speakers to the PSS-150. Inputs Connect all sound sources to the appropriate inputs i. e. , microphones, keyboards, CD players, karaoke machines. The supplied SP-1 StarpowerTM microphone is an allpurpose professional stage and recording microphone with rugged metal construction and excellent clear, transparent sound across the spectrum. When ready to operate, plug the AC cord into the power source. Make sure that the unit is turned off before connecting to the AC power source to avoid possible loud transients which can damage your speakers or your ears. Before turning on, connect up the speakers and all inputs and outputs desired and turn down the Master Volume. 1. INSPECTION Your NADY AUDIO Portable Sound System 150 was carefully packed at the factory in packaging designed to protect the units in shipment. Before installing and using your unit, carefully examine the packaging and all contents for any signs of physical damage that may have occurred in transit. [Please note: Nady Systems is not responsible for shipping damage. If your unit is damaged, do not return to Nady, but notify your dealer and the shipping company (if shipped to you) immediately to make a claim. Such claims must be made by the consignee in a timely manner. ] CONTENTS: · PSS-150 Mixer Section · PSS-150 Left Speaker · PSS-150 Right Speaker · (2x) Speaker Stands · (2x) 2 30' Speaker Cables · SP-1 StarpowerTM Microphone · XC-20 20' Microphone Cable · AC cord · Instruction Manual · Warranty Card 2. SETUP After transporting the PSS-150 to the desired location, lay the unit down on its flat side. Unclasp the side panel latches by pulling up on the yellow tab to release and unhook the latch. Carefully lift off the speakers and then remove the speaker stands and accessories from inside the unit. Mixer Section Position the PSS-150 mixer section on its flat surface with the control panel facing up. Parts of the unit can become very warm during use. Care should be taken to ensure that there is enough space behind the Mixer Section for cooling. Also, do not place the Portable Sound System on high temperature devices such as power amplifiers, etc. , or the unit may overheat in operation. Although the Portable Sound System is shielded against radio frequency (RF) and electromagnetic interference (EMI), extremely high fields of RF and EMI should be avoided. 4 FRONT PANEL CONTROLS & CONNECTIONS (1) (2) (3) (14) (4) (13) (5) (6) (15) (7) (8) (9) (10) (11)(12) (1) CHANNEL 1-3 COMBO XLR / 1/4' INPUT The XLR mic inputs are an electronically balanced XLR type designed to accept mic level signals from any balanced or unbalanced low impedance (Low Z) microphone. The XLR jacks are configured for: Pin1 = ground, Pin2 = positive (+), Pin3 = negative (-). [. . . ] 85 dB mic input typical REVERB/DELAY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . DSP digital reverb and digital delay SPEAKERS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Woofer 10" (254mm) and piezoelectric horn tweeter AC POWER . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 120 VAC(60 Hz0 or 230 VAC (50/60 Hz) DIMENSIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]