User manual NADY DS-50

[. . . ] This also serves as the battery check, so when it dims, replace the battery. · The FOOTSWITCH (7) -- switches between the effect and the unaltered signal with each press. When the effect is on, the LED (7) will light. Introduction Congratulations, you have purchased one the finest effects pedals available. · Classic design for the richest crunchy distortion tone and violin-line sustain available · Volume, Sustain and Tone knobs offer optimum control · Rugged aluminum case for ultimate roadworthiness, long life and reliability · Operates with 9V battery, PAD-1 AC adapter optional Using the DS-50 with Other Effects Place the following effects BEFORE the DS-50: Tremolo Place the following effects AFTER the DS-50: Reverb, Delay, EQ, Chorus, Flanger, Phaser, Pitch Shifter, Wah-Wah, Envelope Follower, Compression Important Notes Please observe these precautions: · Inserting the plug of the instrument cable into the input (IN) jack will switch on the pedal's power supply. [. . . ] Rough handling can cause malfunctions and physical damage not covered by warranty. · Grasp the connecter itself whenever connecting/disconnecting all cables -- never only pull on the cable. Note: For best sound, all effects placed before the DS-50 should be set at unity gain with the signal from the instrument. Specifications Input Impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 M Nominal Input Level . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -20dBu Nominal Output Level . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -20dBu Output Impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 K Recommended Load Impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . >10 K Residual Noise Level (A-weighted) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -90 dBu typical Controls . . . . . . . . . . . . . . . . . . . . ON/OFF Footswitch, Volume Control, Sustain/Distortion Control, Tone Control Indicator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . When dim, replace the battery) Connectors . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . INSTRUMENT IN Jack, OUTPUT Jack, AC ADAPTER Jack (9VDC) Battery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9V Alkaline AC Adapter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . PAD-1 (9VDC), optional Battery Life . . . . . . . . . . . . . . . . . . . 10 hours nominal, alkaline battery, varies depending on conditions of use. Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5. 88" x 3. 88" x 2. 1" Weight (w/o battery) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0. 90 lbs Specifications subject to change without prior notice. DS50_manual 6-7 5/9/05, 10:44 AM · Do not use the unit near power amplifiers (or other equipment with large power transformers) as this may induce hum. To alleviate, simply reorient or move the unit. [. . . ] -), reinsert in the holder, and snap the cover into place (avoid getting the snap cord pinched between the cover and bottom plate). (2) (1) (7) 1. The INPUT (1) jack accepts input signals from guitars or other musical instruments or other effects units. The OUTPUT (2) jack connects the unit to an amplifier or another effects unit. Control: · The VOLUME (3) knob adjusts the output level. Turn clockwise to increase the volume. · The SUSTAIN/DISTORTION (4) knob adjusts long sustain and desired distortion. [. . . ]