User manual NAKAMICHI SR-4

[. . . ] MEMORY Store up to ten, 16-digit 12 char, name & numbers in memory for quick dialing. This memory feature is in addition to the 70 Caller ID records that can be stored in the Caller ID memory log. RECEIVING AND STORING CALLS RINGER (OFF/Lo/Hi) VOLUME (Lo/Mid/Hi) TONE/PULSE FLASH TIME (100/300/600) When you receive a call, the information is transmitted by the phone company to your caller ID telephone. When the memory is full, a new call automatically replaces the oldest call in memory. [. . . ] If necessary, press the ‘#’ button to remove a digit or press a numeric button to insert a digit from left hand side of the displayed number, until the correct number of digits show in the display. Pick up the handset, the number will be automatically dial out after 3 second. Pick up the handset to make the phone in Off-hook first. Use the - or + arrow button to select the CID record. Press the button to dial out the displayed number. Pickup the handset to dial out the numbers. OR Press button then digit [0] … [9] to directly dial out the number. € You have 10 seconds following any key press before the unit automatically return to the summary screen. NOTE: You can exit the setup menu by pressing the button. You can press the button to mute the microphone during the conversation. When the Mute function is activated, the display will show “Muting…”. Incoming and Outgoing Voice Volume Low • Are other phones off hook at same time?If so, this is normal condition as volume drops when additional phones are used at once. • Check the handset receiver volume. SETUP MENU CALLER ID MESSAGE If the part or all of the Caller ID information are blocked by the calling party, the display will show ‘BLOCKED CALL’, ‘BLOCKED NUMBER’ or ‘BLOCKED NAME’. If the part or all of the Caller ID information does not available from the calling party due to the out of area, the display will show ‘UNKNOWN CALLER’, ‘UNKNOWN NUMBER’ or ‘UNKNOWN NAME’. If the part of the Caller ID information is incorrect, the display will show ‘INCOMPLETE DATA’. Se excluyen de la presente garantía los siguientes casos: - Productos dañados por un mal uso o utilización del Producto no conforme a las instrucciones del manual de usuario; - Por una conexión incorrecta o uso inadecuado del producto, en To use this phone, you need an RJ11C type modular telephone jack, which might look like the one pictured here, installed in your home. If you don’t have a modular jack, call your local phone company to find out how to get one installed. Modular telephone line jack IMPORTANT INSTALLATION INFORMATION CAUTION: Disconnect the phone cord from the wall outlet before installing or replacing the batteries. € Never install telephone wiring during a lightning storm. € Never touch uninsulated telephone wires or terminals, unless the telephone line has been disconnected at the network interface. [. . . ] Connect one end of the coiled handset cord to the jack on the handset. Plug the other end of the coiled handset cord to the jack on the base. 1) 2) 3) 4) 5) If you have pulse (rotary) service and want to access customer calling services (such as telebanking and long distance services) that require tone dialing, you can use this feature to temporarily change from pulse to tone service. After dialing the telephone number and connecting to the customer calling service, 1. [. . . ]