User manual NAPCO MAGNUM ALERT-700

[. . . ] Your system consists of a control panel (a computer housed within a white metal panel enclosure), one or more GEMINI Decorator Keypads for controlling the system, and various security detection devices. These detection devices are divided among separate areas known as "zones", set up throughout your premises. Each zone number corresponds to a Zone light on your Keypad's display area. When a zone's number is ON (or lit), it indicates that one or more detection device(s) assigned to that area are active or open. [. . . ] By pressing This will allow, for example, an early morning commuter to exit the house in the morning, without having to disarm and rearm the system, waking the family. wi f , Arming with a System Trouble Present (TROUBLE is lit) immediately clear the trouble, the system can still be armed. For more information, refer to page 11. If the MAGNUM ALERT-700 has a system trouble present, TROUBLE will be lit and the keypad sounder pulsing. If you cannot ollowed by o view the trouble. to view any other troubles, and exit the TROUBLE mode when done. Enter your User Code and pressto arm Note: System troubles should be repaired as soon as possible. 7 f t Oi230a page 7 Tuesday, September 16, 1997 08:26 Emergency Conditions Auxiliary Emergency Enabled?No Emergency Buttons The three sets of emergency buttons, if programmed, are always active whether the system is armed or disarmed. Discuss these Buttons with your installer. The emergency signal will only be activated when the two respective buttons are pressed at the same time. Auxiliary Alarm: Simultaneously press auxiliary emergency, if so programmed. (The nature of this emergency alarm is to be determined by the installer) Police Emergency: Simultaneously press o sound a police emergency alarm, and to alert the central station of a Police emergency, if so programmed. t t o alert the central station of an Ambush Alarm In the event that you are forced by an intruder to disarm your system, the ambush alarm can be activated. When a system trouble does occur , it will caution you by lighting the TROUBLE light and beeping the keypad buzzer. Call installing company for service. 2 Beeps 3 Beeps 4 1-4 Wireless Receiver Jam A problem has been detected with a wireless receiver. Wireless Transmitter Low Battery The battery in a wireless transmitter is low and should be replaced. This transmitter is on the zone corresponding to the number of the lit zone light. The replacement battery for the GEM-Trans2 door/window transmitter, GEM-PIR motion detector and GEM-GB glass break detector is the Duracell DL123A 3 volt lithium. (2 required for the GEM-PIR and GEM-GB. ) The GEM-DT Dual Technology Sensor requires 4 C cell alkaline batteries. Warning: Replace batteries only with the same type as specified above. Use of another battery may present a risk of fire or explosion. Do not recharge or disassemble battery, or dispose of in fire. A problem has been detected with a wireless transmitter. Call installing company for service Call installing company for service. 4 Beeps 1-4 Wireless Transmitter Supervisory Failure Zone Trouble 7 Beeps 1-4 12 Oi230a page 12 Tuesday, September 16, 1997 08:26 Programming User Codes Your Installer has assigned a User 1 Code which can be used to not only Arm and Disarm the system, but also to enter the User Program Mode, where you can program other user codes. [. . . ] Any action for breach of warranty, including but not limited to any implied warranty of merchantab ility, must be brought within the six months following the end of the warranty period. IN NO CASE SHALL NAPCO BE LIABLE TO ANYONE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY, EXPRESS OR IMPLIED, EVEN IF THE LOSS OR DAMAGE IS CAUSED BY THE SELLER'S OWN NEGLIGENCE OR FAULT. In case of defect, contact the security professional who installed and maintains your security system. In order to exercise the warranty, the product must be returned by the security professional, shipping costs prepaid and insured to NAPCO. [. . . ]