User manual NAPCO RP1016LCD

[. . . ] Your alarm specialist will explain your system and show you how it works. Contact him should questions concerning operation arise. These instructions contain important information about the operation of your system with the RP1054D Keypad. Read them carefully and keep them handy for future reference. [. . . ] ARMED/ALARM Light On ­ system is armed. Flashing ­ alarm on a non-24-Hour Zone. Flashing (rapidly) ­ instant protection; entry delay cancelled. STATUS (Green) Light On ­ system disarmed, all non-24-Hour Zones okay. Flashing once every second ­ trouble on any non-24-Hour Zone. Flashing (rapidly) ­ trouble on Day Zone. BYPASS Light On (with red or green light on or flashing) ­ one or more zones manually bypassed. On (with no other lights but with or without a digit displayed) ­ STOP!First Three Lights Flashing (slowly, with digit displayed (except with MA854 and early MA1008 & MA1010 panels)) ­ System trouble: see SETTING THE 6 ALARM WHEN LEAVING. Flashing (rapidly, with pulsing sounder) ­ User Program Mode; press [S] twice to exit. FIRE/TROUBLE Light On ­ Fire Zone in alarm condition. The Chime Mode functions when the alarm system is disarmed (off), but it will always operate on a Never-Arm Zone (see GLOSSARY). To disable the chime feature, hold down Key [5] again (until sounder beeps). Key [6]: TELCO TEST* (Optional; Enabled?YES NO) Pressing the key tests your phone lines (the sounder will start to pulse). If the line is good, the pulsing will stop: if not, a steady tone will sound. (To perform this function, hold down Key [6] until sounder beeps. ) Reset the sounder using Key [9]. Key [7]: FAULT FIND For installer's use only; holding down Reset Key [9] or arming the panel will cancel the Fault-Find Mode. Key [8]: PROGRAM (Alarm functions are disabled while in the Program Mode. ) Allows you to enter the Program Mode, where you can program up to 5 personal User Codes (up to 4 in the MA854), including a Service Code (MA1008 and MA1010 only, optional). Refer to SELECTING AND PROGRAMMING YOUR CODES for more information. (To perform this function, hold down Key [8] until sounder beeps. ) Key [9]: RESET Resets any sounder indication, systemtrouble indication, Day-Zone indication (in MA1008 and MA1010, may be programmed to reset Day-Zone condition), and Fault-Find Mode. After an alarm occurs and the system is disarmed, the numerical display will still indicate which non-24-Hour Zone(s) caused the alarm. [. . . ] To verify which zones have been bypassed, hold down Key [2] until all zones have been displayed. Bypassing Interior Zones Your installer may have also selected all interior zones to be Group Bypass Zones (not for UL installations). Bypass these zones all at the same time by simply pressing Key [S] twice. The yellow BYPASS light will come on whenever you bypass one or more zones. [. . . ]