User manual NAPOLEON GRILLS BUILT-IN GRILLS

[. . . ] If the enclosure is to house a propane cylinder, the tank portion of the enclosure must be ventilated according to local codes, and must not have communication with the cavity used to enclose the gas grill. The tank can not be stored below the gas grill. BUILT IN NATURAL GAS HOOK-UP: The piping up to the gas grill is the responsibility of the installer and piping should be located as shown in the built-in instructions. It must be connected with either rigid pipe, copper tube or an approved flexible metal connector. The installation must comply with CAN B149. 1 Natural Gas and Propane Installation Code in Canada, or to the National Fuel Gas Code, ANSI Z223. 1 in the United States. [. . . ] 6. The entire installation must be leak tested before operating the unit. 2. BIPT750 BUILT-IN INSTRUCTIONS N080-0142 N570-0026 N380-0009 N715-0076 N051-0001 N715-0060 N710-0044 N715-0059 N715-0077 This grill is designed for masonry, non-combustible enclosures only, and must be installed and serviced by a qualified installer to local codes. Attach side mounting brackets and side trim pieces to each side of the grill using 1/4-20 x 1/2" screws (n570-0026). Mount the lower front trim to the bottom front edge of the opening (fasteners not included). Lay the rear trim piece across the back of the opening. To keep it in place, a dab of silicone may be applied to each wing of the rear trim. Lower the unit in place, and connect the gas supply line to the fitting at the end of the manifold. The unit must be secured in place (fasteners not included). This can be accomplished by mounting the left and right trim pieces to the sides of the opening to the sides of the cabinet. 6. The entire installation must be leak tested before operating the unit. 3. BIU405 BUILT-IN INSTRUCTIONS N080-0152 N715-0063 N570-0026 N570-0026 N570-0026 N080-0152 23 e c-c N080-0155 N080-0155 This grill is designed for masonry, non-combustible enclosures only, and must be installed and serviced by a qualified installer to local codes. Access must be provided in the enclosure for drip tray removal and cleaning. Attach the side mounting brackets and the rear trim to the unit using #14 x 1/2" screws (n570-0026). The wings on the rear trim should be under the side mounting brackets. Attach the supplied brackets flush with the front of the opening as per the dimensions in the above drawing (fasteners not included). Lower the unit in place ensuring the brackets installed in the previous step engage between the control panel and the base bracket. Connect the supply line to the fitting at the end of the manifold. The entire installation must be leak tested before operating the unit. 4. BUILT-IN SIDE BURNER INSTRUCTIONS N280-0003P (BLACK) N280-0004 (STN STL) 1. Fit the side burner frame into the opening. The frame should be attached to the opening to prevent any future movement (fasteners not included). Ensure that there is at least 5 sq in of opening in the bottom of the cut out, for combustion air. [. . . ] After the holes are complete, you may once again center the frame in the opening. Starting with the hinged side, shim between the frame and side wall of the opening. Ensure the shims are close to the hinge on the PF style doors. When the frame side wall is plumb, fasten it to the cabinet with screws (not provided). [. . . ]