User manual NAVMAN IN-HULL INSTALLATION

[. . . ] Press and hold the appropriate button to increase/decrease values quickly. Set (12hr) lets you set 12hr or 24hr time format Set (31-12) lets you set dd-mm or mm-dd date format Calc up When `calc up' is «ON» the IN-HULL calculates data for all movement (uphill and downhill). When `calc up' is «OFF» the IN-HULL calculates information for downhill movement only. [. . . ] When `calc up' is «OFF» the IN-HULL calculates information for downhill movement only. Beep When beep is «ON» a beep will sound when the buttons are pushed. Set units (km/h) lets you set speed units to «km/h» or «mph» Distance and altitude are displayed in units corresponding to the speed units, i. e. if you choose «km/h» for speed units, then distance is displayed in «km» and altitude in «m». Set offset lets you adjust the IN-HULL to display local time The date is displayed to ensure that time adjustments are made in the correct direction, i. e. both correct time and correct date should be displayed. To enter setup after starting normal operation, you must shut down and re-start the IN-HULL. Flashing icon = seeking GPS signals Constant icon = GPS signals obtained Startup could take up to 80 seconds to get all satellite data. Enter setup Press and hold to enter setup counter If you release before the counter reaches zero, the IN-HULL will immediately start normal operation. For details about system settings see over page or consult User Guide. Press and hold to leave setup counter After leaving setup, the IN-HULL automatically starts normal operation displaying the speed mode first. IN-HULL Step 3 Go Start normal operation Press to start normal operation When starting directly into normal operation IN-HULL will start in the mode it was in at last shutdown. The IN-HULL automatically operates whenever you are moving and pauses operation while you are stationary. Modes are accessed in the following order: 2 3 AVG MAX 87 Speed Timer RCL RCL Speed AVG Timer Speed MAX Clock Odometer Altitude For details about modes see over page or consult User Guide. Mode example (speed) current speed session distance speed mode icon Mode icons appear in the lower section of the screen. While in Speed mode you can monitor session distance and current speed. You can also store laps and clear session data. [. . . ] While in Speed mode you can monitor session distance and current speed. You can also store laps and clear session data. [. . . ]