User manual NAVMAN MDT850

[. . . ] To view a sub-group, press the selection key matching the sub-group message. 5. 0 MESSAGES 5. 1 TO READ A NEW MESSAGE 1. Press `ENTER' once when the MDT-850 sounds a beep tone (this will also end the beeping) 5. 2 TO REPLY TO A NEW MESSAGE YOU HAVE JUST READ 1. Press `ENTER' twice from the received message to display the list of preset replies 2. Press the `Page Up' and `Page Down' keys to display the reply options 3. [. . . ] You will hear a 2-tone alert when the message is received by the OnlineAVL application 5. The menu will then return to the message page with your abbreviated reply message in the top right corner 5. 5 TO EDIT A MESSAGE This is only for preset reply messages with numbered areas. Select the message you want from the message list 2. Use the `Right' and `Left Function keys to select the digits that need editing 3. Use the `Up' and `Down' Function keys to edit the value 4. Press the `Selection' key matching the edited message to send it 5. You will hear a 2-tone alert when the message is received by the OnlineAVL application 6. The menu will then return to the message page 5 NAVMAN Note: to change a blank space to a number, use the `Up' key. To change a number to a blank space, use the `Down' key after 0. 6. 0 DRIVER ID If the Driver ID (Driver Identification) functionality has been enabled for you MDT by an OnlineAVL user, then a driver is required to enter a Driver PIN to confirm their Driver ID (determined by an OnlineAVL user). The Driver PIN (Personal Identification Number) must be entered within a certain time frame (determined by an OnlineAVL user, eg 40 seconds) after which the MDT will beep until a correct Driver PIN has been entered. The Driver ID Logon screen will appear on the MDT 1012 seconds after the ignition is turned on 2. The number `0' will appear in the space of the first digit. Use the `Up' and `Down' Function key to change this digit to the first digit of your Driver PIN 3. Use the `Right' Function key to move to the space of the next digit of the Driver PIN. Repeat steps 2 & 3 until you have inserted your complete Driver PIN 5. Press `ENTER' to confirm Driver PIN. The MDT will then send your PIN number back to OnlineAVL for authentication. Confirmation may take a few minutes depending on cellular network coverage 6 M D T- 8 5 0 || USER MANUAL If you have entered the CORRECT DRIVER PIN 6. [. . . ] The Driver ID Logoff screen will appear 5. Press `Enter' to confirm your logoff OR press the `Exit' key to cancel the action Note: If you have logged off the Driver ID but have not turned the ignition off, then the Driver ID Logon screen will appear requesting you to logon. 6. 3 IF THE MDT IS BEEPING The MDT will beep to remind you to logon with a Driver PIN. You can stop the beeping by entering a valid PIN number. [. . . ]