User manual NEC LCD2690WUXI

[. . . ] This symbol warns user that uninsulated voltage within the unit may have sufficient magnitude to cause electric shock. Therefore, it is dangerous to make any kind of contact with any part inside this unit. This symbol alerts the user that important literature concerning the operation and maintenance of this unit has been included. Therefore, it should be read carefully in order to avoid any problems. [. . . ] If the monitor detects a signal that is not at the optimized resolution, after 30 seconds a warning message will appear on the screen. When this function is activated, the brightness and contrast of the monitor can be adjusted by using the front buttons without entering the OSM menu. Selecting the factory preset allows the user to reset most of the OSM control settings back to the factory settings. This mode changes the display's screen image from color to grayscale. MANUAL: To rotate the OSM, press the ROTATE OSM button when the OSM is not showing. When the monitor is used in the portrait position, the brightness value will be reduced to 300 cd/m . DDC/CI ENABLE/DISABLE: Turns on or off the two way communication and control of the monitor. Use the SCREEN SAVER to reduce the risk of image persistence. MOTION (Default OFF): Screen image moves periodically in 4 directions in order to reduce the risk of image retention. Timing for MOTION can be set so the screen image moves in intervals from every 10 to 900 seconds. REDUCED: Screen image is reduced to 95% size and is moved periodically in 4 directions. Screen may appear slightly less sharp than normal. Screen image goes outside of the display area in the direction that it shifts so that a portion of the image may appear to be cut off. gAMMA (Default OFF): When OFF , the GAMMA selection that the display uses is the same as the GAMMA selection in Tag5 (page 20). When ON is selected, the GAMMA curve (except PROGRAMMABLE) becomes narrow, reducing the contrast and cutting down the risk of image retention. NOTE: SCREEN SAVER does not function when the TILE MATRIX function is enabled. vIDEO BAND WIDTH (Analog input only): Adjusts the bandwidth of the video signal. Can be used to eliminate undesired video noise from a poor signal. Try this option if the FINE adjustment does not successfully eliminate the noise. sOG THRESHOLD (Analog input only): Adjusts the sensitivity of the Sync On Green input signals. Adjusts the slice level when separating a synchronization from Sync On Green signal input. press "Left" or "Right" to select. [. . . ] Energy saving: This monitor features an advanced energy saving capability. Less than Less than 65W(LCD2690WUXi) 65W(LCD2490WUXi) 1W 1W We hereby certify that the color monitors MultiSync® LCD2690WUXi (L266RZ) MultiSync® LCD2490WUXi (L246T0) are in compliance with Council Directive 73/23/EEC: ­ EN 60950-1 Council Directive 89/336/EEC: ­ EN 55022 ­ EN 61000-3-2 ­ EN 61000-3-3 ­ EN 55024 and marked with Within the European Union EU-wide legislation, as implemented in each Member State, requires that waste electrical and electronic products carrying the mark (left) must be disposed of separately from normal household waste. This includes monitors and electrical accessories, such as signal cables or power cords. When you need to dispose of your NEC display products, please follow the guidance of your local authority, or ask the shop where you purchased the product, or if applicable, follow any agreements made between yourself and NEC. [. . . ]