User manual NEC MAX 920

[. . . ] TalkTime MaxTM 920 Owner's Manual ATTENTION Before Using the Phone: It is necessary that you CHARGE your phone battery fully before attempting to make or receive a call. Battery Disposal: DO NOT PLACE USED BATTERIES IN YOUR REGULAR TRASH. THIS NICKEL-CADMIUM (Ni-Cd) BATTERY MUST BE COLLECTED, RECYCLED OR DISPOSED OF IN AN ENVIRONMENTALLY SOUND MANNER. Battery Recommendations: The NEC TalkTime MAXTM 920 cellular phone you have purchased was designed to deliver quality performance and provide you with years of use. In order to maintain optimum performance, NEC recommends that only NEC Authentic AccessoriesTM be used with the TalkTime phones. Specifically, NEC recommends only the use of Nickel Cadmium (NiCd) batteries with the TalkTime MAXTM 920 phone. [. . . ] 3) Unlocking is carried out in the same way. Press FCN + #, enter in your 4-digit code. When the lock is cleared the display will go back to the standby mode. If the key is incorrect, the display will remain with the FL indicator on the right side of the display. PWR oooo CORRECT PWR oooo INCORRECT FL When the phone is partially locked, only emergency calls (911) and any numbers stored in memory locations 1 through 9 can be made, but any call can be received. Storing to the memory is also prevented. -12- PARTIAL LOCK 1) Press FCN + I. The display will read: PWR EntEr Cd 2) Enter 4-digit lock code. If you key in the correct code, PL (Partial Lock) will appear on the right side of the display. If the key is incorrect, the display will go back to the standby mode. PWR oooo CORRECT PL PWR oooo INCORRECT Note: For security the display will not show the 4-digit lock code. 3) Unlocking is carried out in the same way. When the lock is cleared the display will go back to the standby mode. If the key is incorrect, the display will remain with the PL indicator on the right side of the display. PWR oooo CORRECT PWR oooo INCORRECT PL LENGTH OF YOUR CALLS The phone allows you to check the duration of your calls. Upon sending or receiving a call, the current call timer begins counting. This can be viewed at anytime on the display by pressing FCN + 2. PWR CALL-t 01-16 Minutes Seconds Note: The current call timer will be reset upon receipt or sending of another call. -13- RESETTING THE CALL TIMERS Each NAM has a Total Time Counter. The Total Time of all incoming and outgoing calls are registered by these counters. SINGLE - NAM o To View Total Time: Press FCN + 1. PWR totAl-t 003-29 Hours Minutes DUAL - NAM o To Change NAMs: Press FCN + 6. PWR P-1 214 123-4567 PWR P-2 214 234-5678 o To View Total Time: Press FCN + 1. PWR totAl-t 004-15 Hours Minutes RESETTING TOTAL TIME COUNTER To reset the Total Time Counters: o Press FCN + 1+ #. PWR EntEr Cd PWR totAL-t CLEArEd o Press CLR to exit. -14- BACKLIGHTING The phone keypad and display are illuminated to make them easier to read. [. . . ] Do not use or store in dusty, dirty areas. This will cause permanent damage to moving parts. Do not use harsh chemicals, cleaning solvents, or strong detergents to clean it. Wipe it with a soft cloth slightly dampened in a mild soap-and-water solution. [. . . ]