User manual NEC MT800

[. . . ] CAUTION TO PREVENT SHOCK, DO NOT OPEN THE CABINET. REFER SERVICING TO QUALIFIED NEC SERVICE PERSONNEL. RF Interference WARNING The Federal Communications Commission does not allow any modifications or changes to the unit EXCEPT those specified by NEC Technologies in this manual. Failure to comply with this government regulation could void your right to operate this equipment. This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. [. . . ] ENTER: Stores the setting or adjustments. General Controls Before you turn on your projector, ensure that the computer or video source is turned on and that your lens cap is removed. Turn on the Projector Plug the supplied power cable in the wall outlet. The projector will go into its standby mode and the power indicator will glow amber. Only after you press the "On" button on the projector cabinet or the full function remote control will the power indicator turn to green and the projector become ready to use. NOTE: To turn the projector on by plugging in the power cable, use the menu and enable the "Auto Start" feature. Select the Computer, Video Source or PC Card Viewer Press the Source button on the remote control or the projector cabinet to select "Video" (VCR, document camera, or laser disc player), S-Video", "RGB 1 / 2" (computer or DVD with component output) or "PC Card Viewer" to display the image. Or press the "Menu" button on the remote control or the cabinet and use the menu to select your video source: "Video", "S-Video", "RGB1 / 2", or "PC Card Viewer". Adjust the Image Size and the Focus Use the Zoom ring to adjust the image size, then use the Focus ring knob to obtain the best focus. Use the "Magnify" button (+) or (-) on the remote control to make the image larger up to 400%. Turning off the Projector First press the "off" button on the projector cabinet or the remote control for a minimum of two seconds. The power indicator will go out. CANCEL: Return to the previous screen without storing settings or adjustments. Solid triangle: Indicates further choices are available. A highlighted triangle indicates the item is active. Tab: Indicates a group of features in a dialog box. Clicking on any tab brings its page to the front. Radio button: Use this round button to select an option in a dialog box. Check box: Place a checkmark in the square box to turn the option On. Slide bar: Indicates settings or the direction of adjustment. OK button: Press to confirm your setting. Cancel button: Press to cancel your setting. You will return to the previous menu. E­19 Menu Descriptions & Functions Source Select Source Select RGB 1 RGB 2 Video S-Video PC Card Viewer Enables you to select a video source such as a VCR, DVD player, laser disc player, computer or document camera depending on what is connected to your inputs. Press the "Select" button on the projector cabinet or vw buttons on your remote control to highlight the menu for the item you want to adjust. Play/Stop: Plays back automatically or manually depending on the setting on PC Card Viewer Options of the menu. [. . . ] See page E-12 · Use the Keystone in the Adjustment Menu to correct the trapezoid distortion. See page E-21 · Adjust the focus. · Reposition the projector to improve its angle to the screen. See page E-12 · Ensure that the distance between the projector and screen is within the adjustment range of the lens. [. . . ]