User manual NEC MT800[1].PART1

[. . . ] Your serial number is located under the name plate label on the right side of your MultiSync MT830/1030 . Record it here: CAUTION TO PREVENT SHOCK, DO NOT OPEN THE CABINET. REFER SERVICING TO QUALIFIED NEC SERVICE PERSONNEL. This symbol warns the user that uninsulated voltage within the unit may be sufficient to cause electrical shock. [. . . ] If you're using a mirror and your image is inverted, use the "Menu" and "Select" buttons on your projector cabinet or (v) (w) buttons on your remote control to correct the orientation. (See page 70. ) Screen Mirror REMOTE CONTROL INPUT OUTPUT MOUSE AUDIO CONTROL PC 2 INPUT AUDIO RGB OUTPUT AUDIO MONITOR RGB INPUT R AUDIO INPUT L/MONO S­VIDEO R RGB 1 AUDIO L/MONO INPUT VIDEO Rear Screen Projection You can use your MultiSync MT830/1030 LCD projector to project an image from the rear onto a transparent screen. The distance the projector must be from the screen is the same as if you were projecting the image from the front. Contact your NEC dealer if you need a transparent screen. If you're projecting the image from the rear and your image is inverted, use the "Menu" and "Select" buttons on your projector cabinet or (v) (w) buttons on your remote control to correct the image. (See page 70 . ) INSTALLATION 44 45 Wiring Diagram To video, S-video, and audio inputs on the LCD Projector. VCR, DVD Player or LaserDisc Player Monitor PC CONTROL MOUSE OUTPUT R GB M ON I TOR OU TP U T L / M ON O R AUDIO REMOTE CONTROL INPUT S ­V I D E O I NP U T AUDIO R GB INPUT 1 AUDIO R GB INPUT 2 AUDIO L / M ON O VIDEO I NP U T AUDIO R Remote cable Mouse adapter (For Macintosh) Macintosh or Compatibles (Desk top type) Pin adapter for Macintosh (supplied) Mouse adapter (For IBM PS/2) IBM VGA or Compatibles Document Camera Signal cable (supplied) To mini D-Sub 15-pin connector on the LCD Projector. Remote Control Guideline 1. Plug the serial cable with the mouse output port of the projector into your computer's mouse port and restart your computer to gain remote mouse control. When using the remote control's built-in infrared mouse on a laptop computer, the laptop's mouse, trackball or trackpad will be disabled. Disconnect the serial cable from the mouse output port and restart your computer to regain trackball or trackpad mouse control. If the screen goes blank while using your remote control, it may be the result of the computer's screen-saver or power management software. of memory will run: 640 480 at 16. 7 million colors (24 bit Truecolor) 800 600 at 65 thousand colors. As the resolution increases, the number of colors you can run decreases. of memory a computer will run: 640 480 at 16. 7 million colors (24 bit Truecolor). 800 600 at 16. 7 million colors (24 bit Truecolor). Windows 95 There are two methods you can use to change your resolution. Move your cursor to the background image and click. In the "Properties" menu, select "Settings. " 3. Change your resolution and click "OK. " 4. You may be asked to reboot for the changes to take affect, or you' ll get a message that "Windows is about to resize your display. " You' ll be asked if you want to keep your settings. Click on your "My Computer" icon. Open "Control Panel" and select "Display. " 3. [. . . ] · Use the menu icons to select your source (Video, S-Video, RGB1, 2 or PC Card). (See pages 61 and 62. ) · Ensure your cables are connected properly. · Use icons to adjust the brightness and contrast. · Reset the settings or adjustments to factory preset levels using the RESET icon on the Settings Menu. [. . . ]