User manual NEC MULTISYNC MD21GS2MP Quick Start

[. . . ] MD21GS-2MP 00_MD21GS2MPINSTALLCOVER. P65 1 14/10/2004, 22:33 WARNING TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. ALSO, DO NOT USE THIS UNIT'S POLARIZED PLUG WITH AN EXTENSION CORD RECEPTACLE OR OTHER OUTLETS UNLESS THE PRONGS CAN BE FULLY INSERTED. REFRAIN FROM OPENING THE CABINET AS THERE ARE HIGH VOLTAGE COMPONENTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. CAUTION CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, MAKE SURE POWER CORD IS UNPLUGGED FROM WALL SOCKET. [. . . ] Remove the cable cover by pressing the two tabs to unlock. Lift the cover to remove (Figure B. 1). Figure B. 1 Clip 3 English Quick Start ­continued 4. For digital input: Connect the DVI-D signal cable to the connector on the back of the display (Figure C. 1). For analog input: Connect the 15-pin mini D-SUB signal cable (not included) to the connector on the back of the display (Figure C. 2). NOTE: Incorrect cable connections may result in irregular operation, damage display quality/components of LCD module, and/or shorten the module life. Connect one end of the power cord to the AC inlet on the back of the display and the other end to the power outlet (Figure C. 1). NOTE: Refer to the Display Adjustment & Mounting section to check tilt, raise and lower display screen and screen rotation when you manage cables and power cord. NOTE: Please refer to the Power Cord Important Information section of this manual for proper selection of AC power cord. Collect cables and power cord and place them under the cable clip (Figure B. 1). NOTE: Release the cables from the clip before removing the cable cover. Figure C. 1 Figure C. 2 7. Turn on the display with the power switch on the top (portrait) or left side (landscape) of the display (Figure D. 1). For further adjustments, please refer to the OSM section for a full description of OSM controls. NOTE: NOTE: If you have any problems, refer to the Troubleshooting section. External equipment intended for connection to signal input, signal output, or other connectors, must comply with the relevant IEC standard. Figure D. 1 4 User Controls The On-Screen Manager (OSM) control buttons are located on the back of the display. To access the OSM menu, press any of the user control buttons ( < , >, ­, +). Portrait Mode Landscape Mode 1. LED Indicates power on and signal condition. The LED can be turned on, off, or dimmed. Please refer to the Advanced OSM section/LED Brightness for further information. Green ­ signal is present and power is on Orange ­ no signal Resets the highlighted control menu to the factory setting. Enters the OSM controls and OSM sub menu. Moves the bar left/right to increase or decrease the adjustment. Moves the highlighted area left/right to select control menus. [. . . ] The display should be installed close to a power outlet which is easily accessible. · Handle with care when transporting. Image Persistence Please be aware that LCD Technology may experience a phenomenon known as Image Persistence. Image Persistence occurs when a residual or "ghost" image of a previous image remains visible on the screen. [. . . ]