User manual NEC MULTISYNC MD21GS3MP QUICK START

[. . . ] TO FULLY DISENGAGE THE POWER TO THE UNIT, PLEASE DISCONNECT THE POWER CORD FROM THE AC OUTLET. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. This symbol warns user that uninsulated voltage within the unit may have sufficient magnitude to cause electric shock. Therefore, it is dangerous to make any kind of contact with any part inside this unit. [. . . ] Place the display card into an available PCI slot and secure all screws. NOTE: For installing driver information, display modes in multimonitor mode, the setting the dip switch, please reference the display card manufacturer's documentation. Connecting the LCD to Your PC Once the display card is successfully installed, following these instructions to connect the display to your PC. Shut down your computer and turn off the power. Connect the DVI-D signal cable to the connector of the display card in your system (Figure A. 1). NOTE: for dual displays, plug a DVI-D cable into Port 2 of the display card (Figure A. 1). Remove the cable cover by pressing the two tabs to unlock. Connect the DVI-D signal cable to the connector on the back of the display (Figure C. 1). NOTE: Incorrect cable connections may result in irregular operation, damage display quality/components of LCD module, and/or shorten the module life. Connect one end of the power cord to the AC inlet on the back of the monitor and the other end to the power outlet (Figure C. 1). NOTE: Refer to the Display Adjustment & Mounting section to check tilt, raise and lower monitor screen and screen rotation when you manage cables and power cord. NOTE: Please refer to the Caution section of this manual for proper selection of AC power cord. Collect cables and power cord and place them under the cable clip (Figure B. 1). NOTE: Release the cables from the clip before removing the cable cover. Turn on the monitor with the power switch on the top (portrait) or left side (landscape) of the monitor (Figure D1). For further adjustments, please refer to the OSM section for a full description of OSM controls. NOTE: If you have any problems, refer to the Troubleshooting section. 4 MD21GS3MPquickstart. p65 4 7/22/04, 9:52 AM Quick Start ­continued Figure A. 1 Figure B. 1 Port 2 for Dual Monitor Figure C. 1 Figure D. 1 5 MD21GS3MPquickstart. p65 5 7/22/04, 9:52 AM User Controls 1. LED Indicates power on and signal condition. The LED can be turned on, off, or dimmed. Please refer to the Advanced OSM section/LED Brightness for further information. Green ­ signal is present and power is on Orange ­ no signal 2. On-Screen Key Guide Resets the highlighted control menu to the factory setting. [. . . ] · The power cable connector is the primary means of detaching the system from the power supply. The monitor should be installed close to a power outlet which is easily accessible. · Handle with care when transporting. Save packaging for transporting. CAUTION Image Persistence Image persistence is when a residual or "ghost" image of a previous image remains visible on the screen. [. . . ]