User manual NEC P9210

[. . . ] NEC VERSA P9210 Series Electronic User's Guide Table of Contents Notebook Care Introducing Your NEC VERSA Introducing BIOS Setup for Windows Vista® Introducing BIOS Setup for Windows® XP Windows Vista® Operating System Introduction (Only applicable to Windows Vista®) Windows® XP Operating System Introduction (Only applicable to Windows® XP) Notebook Components Applications Using Your NEC VERSA Preparing for Travel Using Peripheral Devices Setting Up a Healthy Work Environment Problem Checklist Recovery Information for Windows Vista® only Recovery Information for Windows® XP only Frequently Asked Questions Safety Notices Glossary License Agreement Copyright Trademarks Official Name of the Software Used Page 5 7 24 25 27 34 47 48 64 74 76 81 87 89 94 97 104 111 112 114 115 116 2 About Your Electronic User's Guide The illustrations, colours and pictures shown are for descriptive purposes. They may vary slightly from country to country and the unit you purchase. Please refer to the finished product for final configurations. Specifications and model names are subject to change without notice. [. . . ] Unless you use specific label kits, never use a tape or sticky material to label optical discs. Since the data layer of a disk is right beneath the printed label, writing with a pen can scratch the thin reflective aluminium coating. Use soft-tip pens especially for re-writable disks that are even more sensitive. Do not scratch or polish the label side. The pits and lands (microscopic holes and flat areas) that encode the information in the CD are on the label side, and not on the surface read by the lens. Large scratches on the underside, however, can often be repaired using special polishing kits. Most of the time, the laser, which focuses on a layer within the clear base, is able to see past small scratches, in much the same way the human eye can focus on objects outside when looking through a window. Keep the disc away from direct sunlight, high temperatures, and humidity. Keep optical discs away from high temperatures. Don't subject disks at temperature levels exceeding 37°C. Exposure to direct sunlight over long periods easily warps a disk. Low temperatures are not a hazard, but wait for a stable temperature before loading a disk. Disks burned using CD-writer drives are more sensitive and should be stored at room temperature whenever possible. Moisture does not affect other types of discs, but avoid exposing re-writable disks to liquids. In case of accidental spills on discs, rinse it off with lukewarm water and wipe dry with a soft cloth. Be careful with sticky or oily substances that trap dirt and dust. Proper cleaning is important to achieve optimal performance. Using a soft, slightly damp cloth, wipe the disc from inside the disk and rub outwards. Do not wipe in circles but clean in the same outward direction. Wiping the label side in circles can scratch a section of the data track. Slightly dipping the cloth in warm water is enough. Using cleaners and solvents can do damage. [. . . ] NO LIABILITY FOR CONSEQUENTIAL DAMAGES In no event shall NECCAP or its suppliers be liable for any damages whatsoever (including without limitation, damages for loss of business profits, business interruption, loss of business information, or any other pecuniary loss) arising out of the use or an inability to use this product, even if NECCAP or its suppliers has been advised of the possibility of such damages. Because some states/countries do not allow the exclusion or limitation of liability for consequential or incidental damages, the above limitation may not apply to you. 113 Copyright Copyright Notebook Quick Reference, NEC VERSA P9210 Series 2. 0 version, 9/2008. Copyright © 2008, NEC Computers Asia Pacific Sdn Bhd (418989-A) ("NECCAP"). This guide and all software described in it are copyrighted with all rights reserved. [. . . ]