User manual NEC PLASMASYNC 42XM4-(MM)

[. . . ] If you do not do this, this monitor will not conform to mandatory FCC standards. Attaching the ferrite cores: Set the ferrite cores on both ends of the DVI cable (not supplied), and both ends of the power cable (supplied). Close the lid tightly until the clamps click. [. . . ] Use the band to fasten the ferrite core (supplied) to the DVI cable. DVI cable (not supplied) band band Connector core (small) core (small) Power cable (supplied) core (large) core (large) 3 Recommandations importantes Avertissement Ne pas utiliser dans une salle d'ordinateurs telle que définie dans la Norme pour la protection des ordinateurs électroniques/appareils de traitement des données ANSI/ NFPA75. DOC avis de conformation Cet appareil numérigue de la Classe A respecte toutes les exigences du Réglement sur le Matériel Brouilleur du Canada. REMARQUE: Pour raccorder un ordinateur à ce moniteur, procéder à l'aide d'un câble RGB à âme de ferrite aux deux extrémités. Sur les câbles DVI et les câbles d'alimentation électrique, fixer les âmes de ferrite fournies aux extrémités. Si vous ne le faîtes, le moniteur ne sera pas en conformité avec les exigences des standards FCC. Monter les tores en ferrite aux deux extrêmités du câble DVI (non fourni) et aux deux extrêmités du câble d'alimentation électrique (fourni). Fermez doucement le couvercle jusqu'à ce que les crans se clipsent. Fixer le tore en ferrite (fourni) au câble DVI à l'aide d'un collier. Câble DVI (non fourni) Collier Collier Connecteur noyau (petit) noyau (petit) Câble d'alimentation électrique (fourni) noyau (large) noyau (large) 4 Specifications 42VP4PA/42VP4DP-A Screen Size 36. 3"(H) 20. 4"(V) inches 921(H) 518(V) mm diagonal 42" 42VP4PA: Installed AR (Anti-Reflection) Filter 42VP4DP-A: Installed AG (Anti-Glare) Filter 16 : 9 853(H) 480(V) pixels 0. 04"(H) 0. 04"(V) inches 1. 08(H) 1. 08(V) mm 256 levels, 16, 770, 000 colors Horizontal : 15. 5 to 110 kHz (automatic : step scan) Vertical : 50. 0 to 120 Hz (automatic : step scan) RGB, NTSC (3. 58/4. 43), PAL (B, G, M, N), PAL60, SECAM, HD*1 , DVD*1 , DTV*1 40" (1018) 1. 18" (30) 2. 32" (59) 36. 3" (921) 20. 4" (518) Color Reproduction Signals Synchronization Range 24" (610) Aspect Ratio Resolution Pixel Pitch 3. 5" (89) Input Signals Units are in inch (mm) Input Terminals (VIDEO1 and RGB1 can also be used as OUTPUT terminals) RGB Visual 1 (Analog) mini D-sub 15-pin 1 Visual 2 (Analog) BNC (R, G, B, H/CS, V) 1*2 Visual 3 (Digital) DVI-I 24-pin 1*3 Video Visual 1 BNC 1 Visual 2 RCA-pin 1 Visual 3 S-Video: DIN 4-pin 1 DVD/HD/DTV Visual 1 RCA-pin (Y, PB[CB], PR[CR]) 1*1 Visual 2 BNC (Y, PB[CB], PR[CR]) 1*1, *2 Audio Stereo RCA 3(Selectable) External Control D-sub 9-pin 1(RS-232C) Sound output 8W+8W at 6 ohm Power Supply AC120V 50/60Hz Current Rating 3. 7A (maximum) Power Consumption 270W (typical) Dimensions 40 (W) 24 (H) 3. 5 (D) inches 1018 (W) 610 (H) 89(D) mm Weight 62. 8 lbs / 28. 5 kg (without stand) Environmental Considerations Operating Temperature 0°C to 40°C / 32°F to 104°F Humidity 20 to 80% (no condensation) Altitude 0 to 9180 feet / 0 to 2800 m Storage Temperature -10°C to 50°C / 14°F to 122°F Humidity 10 to 90% (no condensation) Altitude 0 to 9840 feet / 0 to 3000 m Front Panel User Controls Power on/off, Input source select, Volume up/down, OSM control Remote Control Functions Power on/off, Input source select, OSM control, Volume up/down, Cursor (UP, DOWN, LEFT, RIGHT), Pointer, Zoom up/ down, Off timer, Wireless/Wired remote control OSM Functions Picture (Contrast/Brightness/Sharpness/ Color/Tint/ Picture mode/Noise reduction/Color temperature/ White balance/Gamma/Low tone/Color tune), Audio (Bass/Treble/Balance/Audio input), Image Adjust (Aspect mode/V-Position /H-Position/V-Height /HWidth/Auto Picture/Fine picture/Picture adjustment), Option1 (OSM/BNC Input/D-Sub Input/RGB Select/ HD Select/Input Skip/All Reset), Option2 (Power management/Cinema mode/Long life [PLE, Orbiter, Inverse, White, Screen wiper, Soft focus]/Gray level/ S1/S2), Option3 (Timer/Power on mode/Control lock/ IR Remote/Loop out/ID number/Video wall [Divider, Position, Disp. mode, Auto ID, Image adjust, Power on delay, PLE link, Timer]), Advanced OSM, Language*, Color system, Source information *English, German, French, Italian, Spanish, Swedish, Chinese 5 The features and specifications may be subject to change without notice. *1 HD/DVD/DTV input signals supported on this system 480P (60 Hz) 480I (60 Hz) 525P (60 Hz) 525I (60 Hz) 576P (50 Hz) 576I (50 Hz) 625P (50 Hz) 625I (50 Hz) 720P (60 Hz) 1035I (60 Hz) 1080I (50 Hz) 1080I (60 Hz) 2 * The 5-BNC connectors are used as RGB/PC2 and HD/DVD2 input. *8 When viewing a moving picture at a vertical frequency greater than 65Hz, the picture may sometimes be unstable (jumpy). If this occurs, please set the refresh rate of the external equipment to 60Hz. To view 480I@60Hz (480 interlaced lines, 60Hz refresh rate) or 576I@50Hz (567 interlaced lines, 50Hz refresh rate) when sync polarity is "Sync on Green", set "RGB SELECT" to "MOTION". NOTE: · While the input signals comply with the resolution listed in the table above, you may have to adjust the position and size of the picture or the fine picture because of errors in synchronization of your computer. · This monitor has a resolution of 853 dots 480 lines. It is recommended that the input signal should be VGA, wide VGA, or equivalent for 42VP4PA/42VP4DP-A. · With digital input some signals are not accepted. [. . . ] It is recommended that the input signal should be VGA, wide VGA, or equivalent for 42VP4PA/42VP4DP-A. · With digital input some signals are not accepted. · The sync may be disturbed when a nonstandard signal other than the aforementioned is input. [. . . ]