User manual NEC PLASMASYNC 61XR4-(MM)

[. . . ] The plasma display panel consists of fine picture elements (cells). Although NEC produces the plasma display panels with more than 99. 99 percent active cells, there may be some cells that do not produce light or remain lit. For operating safety and to avoid damage to the unit, read carefully and observe the following instructions. Provide adequate space for ventilation to avoid internal heat build-up. [. . . ] Adjusting the computer image Only the contrast and brightness can be adjusted when a computer signal is connected. Restoring the factory default settings Select "RESET" under the "PICTURE MODE" settings. 3. Use the and buttons to adjust the picture. CONTRAST * If neither the or button is pressed within 5 seconds, the current setting is set and the previous screen reappears. 18 Setting the picture mode according to the brightness of the room There are four picture modes that can be used effectively according to the environment in which you are viewing the display. Example: Setting the "THEATER" mode Press the PROCEED button on the remote controller to display the MAIN MENU on the screen, then. . . Use the v and w buttons to select "PICTURE", then press the "PROCEED" button. Use the v and w buttons to select "PICTURE MODE". PICTURE CONTRAST BRIGHTNESS SHARPNESS COLOR TINT R PICTURE MODE : MEMORY COLOR TEMP. The picture mode is set to "THEATER". PICTURE CONTRAST BRIGHTNESS SHARPNESS COLOR TINT R PICTURE MODE : THEATER COLOR TEMP. Press the "EXIT" button to return to the main menu. To delete the main menu, press the "EXIT" button once more. Information G EXIT RETURN 3. Use the and buttons to select "THEATER". The mode switches as follows when the and buttons are pressed: MEMORY THEATER NORMAL RESET Types of picture modes MEMORY . . . . . . Use the v and w buttons to select "PICTURE", then press the "PROCEED" button. Use the v and w buttons to select "COLOR TEMP. ". PICTURE CONTRAST BRIGHTNESS SHARPNESS COLOR TINT R PICTURE MODE : MEMORY COLOR TEMP. The "WHITE BALANCE" screen appears. Use the v and w buttons to select "RED-GAIN". WHITE BALANCE GAIN RED GREEN BLUE BIAS RED GREEN BLUE SEL. ADJ. EXIT RETURN 6. Adjusts the white balance using the and buttons. G EXIT RETURN R-GAIN 3. Use the and buttons to select "PRO". The mode switches as follows when the buttons are pressed: 1 2 3 PRO and * If neither the or button is pressed within 5 seconds, the current setting is set and the previous screen reappears. The white balance has now been adjusted. WHITE BALANCE GAIN RED GREEN BLUE BIAS RED GREEN BLUE COLOR TEMP. : PRO SEL. EXIT RETURN If neither the or button is pressed within 5 seconds, the current selection is set and the previous screen reppears. 8. Press the "EXIT" button to return to the main menu. To delete the main menu, press the "EXIT" button once more. Information Adjusting the white balance RGB-GAIN . . . . [. . . ] · Replace both batteries with new ones. · Unplung the remote cable from the monitor. · The front panel buttons do not function during Control Lock. · Plug the monitor's power cord into a power outlet. [. . . ]