User manual NEC XM2961

[. . . ] R 29 Xtra NEC Technologies, Inc. MultiSync is a registered trademark of NEC Technologies, Inc. NEC is registered trademark of NEC Corporation. ©1993 by NEC Technologies, Inc. 1250 N. Arlington Heights Road, Suite 500 Itasca, Illinois 60143-1248 R Multimedia Monitor User's Manual 29 Xtra 29 Xtra R 1 29 Xtra Printed in Thailand 78410091 DOC compliance Notice CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN This Class A digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER. [. . . ] · Do not take apart the batteries, heat them, or throw them into a fire. PROCEED EXIT VIDEO 1 VIDEO 2 RGB 1 RGB 2/DTV POWER /STANDBY Operating Range · The infrared signal operates by line-of-sight up to a distance of approximately 22 feet/7 m and within a 60 degree angle of the remote sensor of the monitor. · The monitor will not function if there are objects between the remote control and the sensor or if strong light falls on the sensor. Weak batteries will also prevent the remote control from properly operating the monitor. 30 DEGAUSS POWER OFF ON RGB 2 PROCEED EXIT 30 VIDEO 1 VIDEO 2 RGB 1 POSITION / CONTROL SCAN WIDTH HEIGHT SIDE PIN NORMAL NORMAL BRIGHT CONTRAST MUTE VOLUME MULTIMEDIA MONITOR RD-354E 79645721 16 13 17 Functions of DIP SW ON ON Functions and Settings of DIP SW This DIP switch is used for Sync. Control, Intelligent Power Manager, External control, wireless control, and OSM control. To change a switch setting use a pointed object, such as a pen or pencil, to push the switch to the desired position. Set all the pins except No. 7 to the OFF position during normal operation. 1 pin to the OFF position during normal operation. The monitor automatically determines if the input signal is separate sync, composite sync or sync on green signal in this order. 1 pin to the ON position when sync on green signals are necessary for synchronization with an external component. 1 2 3 4 5 6 7 8 OFF Pin No. 4 (Intelligent Power Manager) This function saves power. When Intelligent Power Manager control is on, by using the monitor' s horizontal and vertical SYNC signals, the monitor can be prompted into the different IPM modes. The following is the description of the LED indicator for the IPM power saving modes: Mode On Standby Standby State Suspend State Off State Power Off LED Indicator Green Red (Steady) Amber(Blinking quickly) Amber(Blinking moderately) Amber(Blinking slowly) No Light Power Saving None None Minimum (Quickest recovery) Moderate (Moderate recovery) Maximum (EPA<8 watts, Slowest recovery) No Power Used (Fully Off) Pin No. CONTROL) When this switch is set to ON, the External Control function is activated. 7 (REMOTE ON/OFF) When this switch is set to ON, the monitor can be controlled by the wireless remote control unit. If you have some monitors you do not want to control by remote, set to OFF. 8 (OSM System Control Menu ON/OFF) When this switch is set to ON, the system control menu is displayed. In this menu the following features are enabled: Power on mode set(POWER ON MODE) Front control key on/off(FRONT CONTROL) Language selection(LANGUAGE) Video mode(auto/manual) selection(VIDEO MODE) OSM on/off(OSM ON/OFF) PC-control on/off(PC-CONTROL) CONVERGENCE SETUP For the setting procedures to set the items, see pages 43 to 45. NOTE: The Intelligent Power Manager works only for the RGB input. If selecting the VIDEO input, or when connecting to no signal source, the Intelligent Power Manager does not work. 18 14 19 Installation Wiring Diagram IBM XGA/SuperVGA/VGA or Compatibles or Macintosh G3 series Macintosh or Compatibles EXTERNAL CONTROL RGB Cable (supplied) To Mini D-SUB 15 Pin input Pin adapter for Macintosh (supplied) RGB Cable (supplied) To Mini D-SUB 15 Pin input XP29 Xtra/XM29 Xtra SPEAKERS MUST HAVE MORE THAN 5WATT RATING IMPEDANCE 8 OHM To EXTERNAL CONTROL (Mini D-SUB 15 Pin input) RGB1 AUDIO R L(MONO) IN S VIDEO 1 BNC DIP SW ON REMOTE IN PC / EXT CTL EXT SPEAKERS RIGHT LEFT 75 IN HIGH 75 IN HIGH THROUGH OUT 12345678 To R, G, B, H, V inputs (BNC) NEC IPS 4000 Image Processor THROUGH OUT THROUGH OUT OUT SPEAKER SELECT INT EXT VIDEO 2 BNC S R IN AUDIO L(MONO) RGB AUDIO 75 R IN L(MONO) HIGH IN R/CR/PR RGB 2 G/Y/Y B/CBPB H/CS V 75 IN HIGH 75 HIGH AC IN THROUGH OUT THROUGH OUT THROUGH OUT THROUGH OUT To Y/CB/CR, Y/PB/PR inputs (BNC) DTV Tuner or DVD Player To VIDEO IN R, L, inputs Document camera, VCR, Video copy stand or Multimedia application PROCEED EXIT VIDEO 1 VIDEO 2 RGB 1 RGB 2 POWER /STANDBY XP29Xtra/XM29Xtra 20 15 21 Connecting Your PC or Macintosh Computer Connecting your PC or Macintosh computer to your MultiSync XP29 Xtra/ XM29 Xtra will enable you to display your computer's screen image. All of these following display standards are supported: VGA 640 x 480 for graphics, VGA 640 x 400 for graphics, VGA 640 x 350 for graphics, VGA 720 x 400 for text, VGA 720 x 350 for text, SuperVGA 800 x 600, and XGA 1024 x 768, 1280x1024 standards above 60 Hz such as Sun, Silicon Graphics, HP, workstation standards; Macintosh at 640 x 480, 832 x 624, 1024 x 768, and 1152 x870(XP29 Xtra only). To connect to a PC, Macintosh or computer equipped with a XGA/SuperVGA/ VGA adapter or compatible graphics adapter, simply: 1. Turn off the power to your monitor and computer. If your PC does not support XGA/Super VGA/VGA you will need to install an XGA/SuperVGA/VGA graphics board. Consult your computer's owner's manual for your XGA/SuperVGA/VGA configuration. [. . . ] For the location of your nearest authorized NEC service center. To report a DOA product and verify its status for return authorization. On-site Service/Repair Policy NEC offers on-site service and repair for all of our MultiSync presentation monitor products of 29'' and larger screen size. Warranty repair is provided by our service-authorized Visual Systems Division Dealers and network of factory-trained independent service providers. If you are experiencing a problem with your monitor, please contact the authorized NEC Visual Systems Division dealer from which it was purchased. [. . . ]