User manual NEFF B46C74N3FR

[. . . ] This appliance is intended for use up to a maximum height of 2000 metres above sea level. If the appliance is being installed under a hob, refer to the assembly instructions for the hob. For installation under an induction hob, the work surface thickness must be min. [. . . ] Otherwise, the correct operation of electrical components may be adversely affected. Parts that are accessible during installation may have sharp edges. Wear protective gloves to prevent injury from cuts. Secure freestanding units to the wall using standard, commercially available brackets A. Permanently fix furniture units to the worktop. 1 To ventilate the appliance, there must be a gap of 20 mm between the intermediate floor and the wall. The gap between the worktop and the appliance must not be closed using additional battens. Ensure that there is sufficient clearance B for the front panel and its handles. Check that the appliance door can be opened properly. 3 To ventilate the appliance, there must be a gap of 20 mm between all intermediate floors and the wall. Only fit the appliance up to a height which allows accessories to be easily removed. Connecting the appliance to the power supply The appliance is fitted with a plug and must only be connected using the power cable provided. The fuse protection must correspond to the power rating specified on the appliance's rating plate and to local regulations. The appliance must only be connected to a protective contact socket which has been correctly installed. [. . . ] Disconnect the appliance from the power supply. Open the appliance door slightly and unscrew the left and right- Lift the appliance slightly and pull it out completely. A faulty power cable must only be replaced by a special replacement power cable from the manufacturer or from aftersales service. [. . . ]