User manual NEFF D79T48N0GB

[. . . ] Installation instructions and how to use and look after your built-in cooker hoods NEFF (UK) Ltd Fig. 550 2 Instructions for use: Appliance description Chimney panelling Operating modes This can be achieved if combustion air can flow through non-lockable openings, e. g. in doors, windows and via the airintake/exhaust-air wall box or by other technical measures, such as reciprocal interlocking, etc. If the air intake is inadequate, there is a risk of poisoning from combustion gases which are drawn back into the room. [. . . ] Then brush the filters clean, rinse them thoroughly and leave the water to drain off. Removing and inserting the metal grease filters: Warning: The halogen bulbs must be switched off and cool. Press the catch on the grease filters inwards and fold the filters down. At the same time take hold of the underside of the grease filters with your other hand. 2. Insert the clean filters back into the hood. Press the L button for at least 3 seconds. The # is cancelled. 9 Filters and maintenance Activated carbon filter: For neutralizing odours in recirculating mode. Caution: As the filter becomes more and more saturated with grease, there is an increased risk of fire and the function of the extractor hood may be impaired. Important: Change the activated carbon filter promptly to prevent the risk of fire from the accumulation of heat when deep-fat frying or roasting. Installation and removal: Warning: The halogen bulbs must be switched off and cool. Remove the metal-mesh filters (see "Removing and inserting the metalmesh grease filters"). Saturation indicator: b When the activated carbon filter reaches saturation point, an acoustic signal is sounded for 6 seconds after the fan has switched off, and a b appears in the display. The activated carbon filter should be replaced straight away. Replacing the activated carbon filter: During normal operation (1 to 2 hours per day) the activated carbon filters should be replaced approximately 1 x year. A replacement filter can be obtained from any authorized dealer (see optional accessories). By doing so you will obtain maximum performance from your extractor hood. Disposing of the old activated carbon filter: There are no pollutants in the activated carbon filters. If the extractor hood responds too quickly or too slowly in automatic mode: See section entitled "Sensor control". If is not possible to operate the extractor hood: Disconnect the extractor hood from the mains electricity supply by pulling out the plug or switching it off at the main fuse box. If you have any questions or if a fault occurs, please call Customer Service. (See list of Customer Service representatives). When you call, please quote the following: 3. [. . . ] Remove the grease filter (refer to Operating Instructions). Draw a line on the wall from the ceiling to the lower edge of the hood at the centre of the location where the hood is going to be mounted. Use the template to mark the points on the wall where the screws will be mounted. In order to make it easier to hook the hood onto the screws, draw the outline of the area where the hood will be attached. [. . . ]