User manual NEFF D91T7N0GB

[. . . ] Installation instructions and how to use and look after your built-in cooker hoods D91T7 NEFF (UK) Ltd Fig. 1 ELECTRO 2 Operating Instructions Appliance description Chimney panelling Light / fan switches Operating modes This can be achieved if combustion air can flow through non-lockable openings, e. g. in doors, windows and via the airintake/exhaust-air wall box or by other technical measures, such as reciprocal interlocking, etc. If the air intake is inadequate, there is a risk of poisoning from combustion gases which are drawn back into the room. [. . . ] Press the J button. Filters and maintenance Activated carbon filter: For neutralizing odours in recirculating mode. Caution: As the filter becomes more and more saturated with grease, there is an increased risk of fire and the function of the extractor hood may be impaired. Important: Change the activated carbon filter promptly to prevent the risk of fire from the accumulation of heat when deep-fat frying or roasting. Inserting the filter: Warning: The halogen bulbs must be switched off and cool. Remove the metal-mesh filters (see "Removing and inserting the metalmesh grease filters"). Saturation indicator: U b When the activated carbon filter reaches saturation point, an acoustic signal is sounded for 6 seconds after the fan has switched off, and a J b appears in the display. The activated carbon filter should be replaced straight away. Removing the filter: Warning: The halogen bulbs must be switched off and cool. Press the catches at both sides of the filter inwards and lift the carbon filter down and out. 3. Replacing the activated carbon filter: During normal operation (1 to 2 hours per day) the activated carbon filters should be replaced approximately 1 x year. A replacement filter can be obtained from any authorized dealer (see optional accessories). By doing so you will obtain maximum performance from your extractor hood. Disposing of the old activated carbon filter: There are no pollutants in the activated carbon filters. They can therefore be disposed of as part of your normal domestic refuse. Insert the metal grease filters (see "Removing and inserting the metal grease filters"). Press the J button. Cleaning and care Isolate the extractor hood by pulling out the mains plug or switching off the fuse. When cleaning the grease filters, remove grease deposits from accessible parts of the housing. This prevents the risk of fire and ensures that the extractor hood continues operating at maximum efficiency. Clean the extractor hood with a hot soap solution or a mild window cleaner. Do not scrape off dried-on dirt but wipe off with a damp cloth. Do not use scouring agents or abrasive sponges. Note: Do not use alcohol (spirit) on plastic surfaces, as dull marks may appear. [. . . ] If the connecting cable for this appliance is damaged, the cable must be replaced by the manufacturer or his customer service or a similarly qualified person in order to prevent serious injury to the user. This extractor hood corresponds to EC regulations concerning RF interference 13 suppression. 1. While { is displayed, press the button until ã is displayed. When this has taken place, release the buttons. [. . . ]